Could LaSalle Bristol Roof Vent Install Kit Work with MaxxFan 7000k Roof Vent

Question

Question:

I have a MAXXFAN 7000K, the instructions says to use a sealant that does not have solvents in it. Would the LaSalle Bristol XTRM Universal be a good choice ? or do you have better suggestions ? This is on a new install on a cargo trailer

asked by: David

0

Expert Reply:

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part # 344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great choice.

expert reply by: Jameson C

0

Answer 1

You would want to run a bead of the sealant around the vent opening on the underside of the mounting flange as shown in red on the photo I edited for you. Put the vent into place, pressing firmly so that the sealer spreads to the area around the…

view full answer...

Answer 2

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The only real difference between the Alpha Systems #AL74UV and the LaSalle Bristol #3441700534142711440 is that the Alpha Systems is made of TPO which is a bit less flexible than Elvaloy-based PVC that #3441700534142711440 uses; PVC is going to be a…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Most slides have EPDM rubber roofs but because EPDM is rubber it requires treatment each year to keep it soft and prevent shrinkage. You could replace it with TPO which is another synthetic rubber that will last longer than the EPDM. The smallest…

view full answer...

Answer 8

The Alpha Systems Superflex TPO RV Roof Membrane #AL25CV is 0.30" thick. This is the only thickness they offer currently for the TPO. You will need the Alpha Systems RV Roof Replacement Installation Kit #AL63FJ to install this roof membrane.

view full answer...

Answer 9

Yes it will accept PVC adhesive, the felt backing will soak it up and help create a strong connection/bond. The adhesive has a longer life span than butyl tape and it is cleaner than using caulk or other sealants. It will need to be treated with…

view full answer...

Answer 10

We do have the panels separately. What you're looking for is the Go Power Overlander Expansion Kit - 200 Watt Solar Panel #34282182.

view full answer...

Could LaSalle Bristol Roof Vent Install Kit Work with MaxxFan 7000k Roof Vent

Product Page this Question was Asked From

Continue Researching