Replacement Electric Trailer Brake Assemblies For a 2018 Jayco Jay Feather 29QB Travel Trailer

Question

Question:

I have a 2018 Jayco Jay Featehr 29QB and it has Lippert 3700# axels under it. Which trailer brakes do I need for this setup?

asked by: Kevin M

0

Expert Reply:

You will need the Electric Trailer Brake Kit # AKEBRK-35-SA for your Lippert axle on your 2018 Jayco Jay Feather 29QB travel trailer. These are sold as a set with one Left # AKEBRK-35L-SA and one Right # AKEBRK-35R-SA assembly. So be sure to get 2 kits for both axles on your Jayco.

expert reply by: Bud M

0

Answer 1

Thank you for providing the reference numbers from your Jayco trailer's Dexter axle. I was not able to cross reference either of these numbers, 123617439 and 1657213, but we can still help you. It appears that one of the other bits of info you…

view full answer...

Answer 2

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 3

Actually, there's a little more to it than that. The magnets on the #K23-478-479 are a little different, but the primary difference is the mounting bolt pattern. On a typical 3500 lb brake assembly, the mounting studs will all be 2-7/8 inches…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 7

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

view full answer...

Answer 11

Since Grand Design is kind enough to list certain parts for their trailers I can confirm you have a 33" wheelbase on your 2020 Grand Design Transcend 27BHS. This means the MORryde Rubber Equalizers #MR87ZR will fit your trailer. Although I'm…

view full answer...

Answer 12

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Replacement Electric Trailer Brake Assemblies For a 2018 Jayco Jay Feather 29QB Travel Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching