Replacement Short Rear Legs for Lippert Ground Control 3.0

Question

Question:

I have a Ground Control 3.0 system which is a 4 jack system. I want to replace the rear jacks due to their length which only gives me a couple of inches of ground clearance in the up position. Question 1: Does the jack come with a removal pad which is what I have now? Question 2: Any idea when a matching right side would be available? Thanks.

asked by: Kirk

1

Helpful Expert Reply:

Yes, the Short Left Leg # LC342610 is paired correctly with the Short Right Leg # LC428493 for the Lippert Ground Control 3.0 leveling system. The foot pad is not removeable though so you'll want to take that into account for your clearance.

Attached is a review video for you to check out.

expert reply by: Jon G

1

Answer 1

Since your 2019 Open Range 374BHS has the Lippert 6 point Ground Control system and the foot plate is pinned in place the part #LC344792 that you referenced is the correct leg. The part #LC428493 is for if the foot is welded to the jack leg.

view full answer...

Answer 2

Thank you for the picture with the measurement of your current Lippert Ground Control right rear leg that measures 24-1/2 inches from top to bottom when retracted. Based on that the correct replacement is the part #LC344792 and not the one you…

view full answer...

Answer 3

I was able to find the service manual for the Lippert Ground Control 3.0 #LC358590 and found in that where Lippert recommends if the jacks are down for extended periods, it is recommended to spray exposed leveling jack tubes with lubricant every 3…

view full answer...

Answer 4

If your 7K axles have overslung leaf springs (sits atop the axle), the SumoSprings TSS-107-47 which we sell as part #SS26MV would for well for you. The kit includes a line relocation kit in case there's a wiring harness, water or gas line in the…

view full answer...

Answer 5

I do have a recommendation for you as switching out all your leaf springs on your 2021 Keystone Carbon 358 is a big undertaking. The SumoSprings Trailer Helper Springs #SS26MV are designed to work on 5,000lb to 8,000lb trailer axles and each set…

view full answer...

Answer 6

Since we know your 2017 Grand Design Reflection 303RLS has 7,000 lb axles we do have one leaf spring replacement that is the correct capacity with the part #DX74XR but this is a 7 leaf spring that is 24-7/8 inches long from eye to eye. You'd want…

view full answer...

Answer 7

If you are getting inside tire wear on the rear axle of your fifth wheel that would indicate that your trailer is sitting a little nose high and putting additional stress on the rear axle. If you look at your trailer when it's connected to your…

view full answer...

Answer 8

Lippert actually has 2 inch shorter versions of the rear jacks of the Lippert ground control with the part #LC342610 for the left rear and then #LC428493 for the right hand side. We also have the lift kit part #RR23QX which can give your trailer a…

view full answer...

Answer 9

The Replacement Short Left Rear Leg #LC342610 uses 1/2"-20 x 1-1/2" bolts to attach to the Jack Bracket for Lippert Ground Control 3.0 #LC349975. I'm not entirely certain what you are referencing in terms of "whole kit" but if…

view full answer...

Answer 10

The Replacement Left Rear Leg for Lippert Components Ground Control 3.0 Electric Leveling System - Qty 1 #LC305339 is the replacement leg you want. The Lippert #LC342610 is 2 inches shorter and is for travel trailers with this system versus 5th wheel…

view full answer...

Answer 11

Other than potentially pinching or damaging the wiring on your Ground Control 3.0 System #LC358590, I don't see any reason why you can't do this; it's really no different than taking the jack off and re-installing it. My tech contact over…

view full answer...

Answer 12

I have a ground clearance answer for you. As far as the shortest retracted length, the Replacement 22-1/2" Right Rear Leg for Lippert Ground Control 3.0 Electric Leveling System #LC428493 and the Replacement Short Left Rear Leg - Ground Control…

view full answer...

Replacement Short Rear Legs for Lippert Ground Control 3.0

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching