Wiring Needed To Rewire A Sled Bed Enclosed Snowmobile Trailer
Question:
I have a sled bed enclosed Snowmobile trailer. Wiring runs through the frame. What wiring kit do I need to redo all the wiring? Thanks
asked by: Terry W
Expert Reply:
For your sled bed enclosed snowmobile trailer, the first place to start when rewiring is with a junction box, like the Epicord 7-Way Molded Trailer Plug with Junction Box # 277-000141.
To install this, you will need to pick a location on your trailer frame that allows the 10' 7-way lead to reach the front of the trailer.
For the remainder of the wiring you can use # 10-1-1 which you'd run for your ground, 12v accessory, and brake output.
For the the lighting, you can use the Bonded 4 Wire # 16-4B-1 in which you can separate the wires and run them to each light assemblies.
Additionally, # 10-1-1 and # 16-4B-1is sold by the foot, so keep that in mind.
Products Referenced in This Question
Product Page this Question was Asked From
Epicord 7-Way Molded Trailer Plug with Junction Box - 10' Long
- Accessories and Parts
- Trailer Wiring
- Junction Box
- Epicord
more information >
Continue Researching
- Shop: Epicord 7-Way Molded Trailer Plug with Junction Box - 10' Long
- Q&A: Parts Needed To Add Electric Drum Brakes To A Pontoon Trailer
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Adapter and Re-Wiring Kit for Lance Truck Camper with Round Pin 7-Way Plug
- Article: Most Popular Wheel Bearings
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tire Sizing
- Q&A: Recommended Replacement Weatherproof Junction Box/7-Way Pigtail
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Q&A: Recommended Spare Tire for a Rove 14L Trailer w/ ST235/75R15 Tires
- Q&A: 7-Way and Junction Box Kit Recommendation for Trailer with 4-Way
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub