Slide-Out Tray For a Generator with 24" x 34" Base Dimensions

Question

Question:

I am looking for a generator tray to use with an o an generator base dimensions 24 x 34 slide out tray

asked by: James

0

Expert Reply:

For a slide-out tray that will fit your generator that has base dimensions of 24" x 34" you can use the MORryde RV Cargo Sliding Tray # MR37FR which has measurements of 36" x 26" and can hold up to 800 lbs.

expert reply by: Scott S

0

Answer 1

We do offer a direct replacement for the Dometic Duo-Therm RV Air Conditioner. The Advent Air RV Air Conditioner part #ACM135 for 13.5K or part #ACM150 for 15K is what I recommend. This unit will be a plug and play fit and it will work with your…

view full answer...

Answer 2

Advent Air Conditioners like part #ACM135 come with a connector that pairs up directly with the standard 6-wire connector. If you have a 9-wire connector then you need the kit #ACRG15 as well. For wiring I'm attaching some photos of diagrams for…

view full answer...

Answer 3

For an RV with a currently installed Dometic Duo-Therm 59516.531 AC unit, I recommend the Advent Air for Dometic Setups, #ACDOM150. This is a 15,000 Btu replacement option that plugs directly into your current Dometic setup and works seamlessly with…

view full answer...

Answer 4

Hi Robert, If you're just wanting to replace the condenser unit on the rooftop and retain use of your current air distribution box and thermostat then you'll just need to determine what style connector your current unit has. If you remove the…

view full answer...

Answer 5

I agree, that note doesn't make sense. When I reached out to my contact at MORryde they said the MORryde RV Generator Slide Out Tray #MR79RR doesn't have a stopper for when the tray is in the fully opened position so you just need to make…

view full answer...

Answer 6

There unfortunately isn't a guide to tell us the equalizer, shackle straps, and leaf spring sizing for your 2016 Grand Design Reflection 313RLTS so you'll need to a bit a of measuring to determine the best replacements. Before measuring…

view full answer...

Answer 7

If you have the ACTH12 then you should also have the Air Distribution Box #ACRG15 which will have a control box for your wiring from the rooftop unit #ACM135 and the thermostat. This air distribution box and thermostat will wire up exactly the same…

view full answer...

Answer 8

We do not carry the Reico-Titan products so my research was more limited but after doing some research I was able to locate the installation instructions for the Reico-Titan Jacks. They have brackets listed specifically for the "C" clamp…

view full answer...

Answer 9

The closest option we have to the dimensions you described is going to be the MORryde RV Cargo Sliding Tray #MR37FR, which is 36" Long x 26" Wide and has a 60% extension. It has an 800lb capacity, which is well above the 50-75lbs you're…

view full answer...

Answer 10

Roadmaster Rear Anti-Sway Bar part #RM-1139-146 can only be installed in one orientation. It is not designed to be installed upside down. I have attached a photo of what the installation should look like.

view full answer...

Answer 11

If your Kwikee Steps #LC3711363 all of a sudden aren't operating correctly on a nearly brand new motorhome then my first recommendation would be to check the wiring for any damage or loose connections and then test the ground and the 12v power…

view full answer...

Answer 12

Yes. Since you know your 2019 Forest River Wolf Pack 325/13 uses an equalizer that is 5-3/4" long you'll be able to use the MORryde Rubber Equalizers #MR87ZR for an upgrade. It's a good idea to go ahead and upgrade your shackle straps…

view full answer...

Slide-Out Tray For a Generator with 24" x 34" Base Dimensions

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching