Will a 175/80-13 Trailer Tire Fit on a 4-1/2 by 13 Inch Wheel

Question

Question:

I have 175/80/13 tires will they fit On this rim? Or witch rims will fit this tire

asked by: Gabe

0

Expert Reply:

A 175/80-13 trailer wire will fit on 4-1/2, 5, and 5-1/2 inch wide 13 inch wheels. Since wheel # AM20232 is a 4-1/2 inch by 13 inch wheel, your tires will fit. I have included a link to our tire size FAQ article that shows what size wheel a given tire size will fit.

expert reply by: Michael H

0

Answer 1

The closest trailer tire size to the 155/13 that you have would be the ST175/80-13 like the part #AM10210. This will be a little bit wider but it will still fit. This will be 20 mm wider than what you have now.

view full answer...

Answer 2

The Westlake 215/75R17.5 Radial Tire w/ 17-1/2" Wheel #LHAS701 does not include the balance beads, or any balancing done when the manufacturer mounts the tire and wheel combination. We do offer the balance beads if you would like to have them…

view full answer...

Answer 3

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 6

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 7

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 8

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 9

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 10

You can add larger wheels and tires to a trailer as long as you have enough room for the larger size. The main clearance issues we find when putting larger tires and wheels on a trailer is from the top of the tire to the fender and from the inside…

view full answer...

Answer 11

A ST205/75R14 trailer tire is going to have a diameter of about 26.3" and a width of 8.1" when inflated. If we go up to a 15", the ST205/75R15 tires are about 27.3" in diameter and 8.1" wide. So, they have the same width, but…

view full answer...