Grease Seal # RG06-090 Replacement Recommendation for DL600 Seals

Question

Question:

I want to buy some additional grease seals, as I only have one pair left. They are BAL seals part # 32048 and list DL600 and the size as 3.372 bore/2.125 shaft. I prefer a double lip seal, as it gives a better seal agains grease leaks. Is the RG06-090 the correct replacement seal?

asked by: Robert G

0

Expert Reply:

The DL600 seals you referenced have the same dimensions as the TruRyde Seals # RG06-090 that you also referenced. The # RG06-090 should work very well for you, and are double-lip like you wanted.

expert reply by: Jameson C

0

Answer 1

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 2

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...

Answer 3

We sure can! The Transcom #TCM 21344 TB cross references to the 10-10 seal we offer, part #RG06-090. The seal has a 2.125 inch ID and a 3.376 OD. It's compatible with a 25580 inner bearing.

view full answer...

Answer 4

The Transcom #TCM 21344 TB cross references to the 10-10 seal we offer, part #RG06-090. The seal has a 2.125 inch ID and a 3.376 OD. It's compatible with a 25580 inner bearing.

view full answer...

Answer 5

The side plates of the B&W gooseneck trailer hitch #BWGNRK1313 will mount on the outside of each frame rail of your 2004 Dodge 2500 8-foot bed. See the B&W video I included at the 7 min and 30 second mark. If your Firestone air bags like…

view full answer...

Answer 6

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 7

I went out to the warehouse and took several measurements of Curt Hook with Spring Loaded Safety Latch #C81840 for you. I have included a picture showing the measurements.

view full answer...

Answer 8

You can verify that the 10-19 grease seal included in Bearing Kit #BK2-100 is the correct one for your spindles by taking two measurements. First you want to measure the rear hub bore where the seal is inserted. The seal's outer diameter needs to…

view full answer...

Answer 9

To get power to the controller of your Solera Smart Arm 12V Power RV Awning part #LC759404, you need to tap into an existing circuit, or run a power wire from the battery with an inline fuse holder, and a 15 amp fuse, like part #SWC9538, and part…

view full answer...

Grease Seal # RG06-090 Replacement Recommendation for DL600 Seals

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching