Availability of Lippert Venture Lead Leg Repair kit part # LC146059

Question

Question:

i seen where you have a lc146059 kit available to repair a older atwood landing gear but i cannot find it on your website

asked by: Charlie

0

Expert Reply:

We still carry the Lippert Venture Lead Leg Repair kit part # LC146059 that you are looking for. The product link is down below.

expert reply by: Jameson C

0

Answer 1

I have a solution for you and just as an FYI, Lippert had some difficulties with manufacturing and materials procurement during the pandemic; the Heavy Duty Driver Leg for Lippert Ground Control 2.0 Landing Gear #LC241846 was one of their parts that…

view full answer...

Answer 2

I linked the schematic diagram for Lead Jack Repair Kit #LG-146059 taken from the written instructions. The complete instructions will be sent to you in a separate link. The follow leg repair kit is part #LC146060 in case you need it.

view full answer...

Answer 3

There will be a roll pin that runs through the bottom of the bevel gear you have on your Venture landing gear VMC900R that will need to be driven out before it can be removed. You would need to use a punch or a thin screwdriver to get it out.

view full answer...

Answer 4

The Lippert part number you referenced is for the Ground Control 2.0 system which you'd have to use the part #LC241845 as a replacement for. There isn't a Stromberg part number that will work.

view full answer...

Answer 5

For the Venture landing gear, I recommend the Lippert Components Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear #LC146059 and the Lippert Components Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear #LC146060.

view full answer...

Answer 6

Yes, I attached a diagram you can use to install the #LC146059 that you referenced.

view full answer...

Answer 7

For the driver leg part #LC241846 that you have the correct repair kit you'll want is the #LC146059.

view full answer...

Answer 8

The 241845 actually comes back to the Replacement Heavy-Duty Landing Gear Jack Leg #LC241845 which is the replacement leg for the Ground Control 2.0 which does not have a gear repair kit available so you would need to replace the leg with a new…

view full answer...

Answer 9

I have attached for you a set of photos which are used to identify the landing gear legs on a trailer. I assume you have either the older Lippert Ground Control 2.0 Leveling System or the newer Lippert Ground Control 3.0 Leveling System. If that is…

view full answer...

Answer 10

The part #LG-179013 is the replacement lead leg which means it's the one you attach the crank handle to and then the part #LG-179014 is the follow leg which attaches to the lead leg via a shaft. If this is the type of landing gear you have and…

view full answer...

Answer 11

Sounds like you are looking for just the lead leg for the landing gear you have on your trailer. Since I do not know what landing gear you have on your trailer I attached a link to a page that has all of the lead legs we offer. You would want to…

view full answer...

Answer 12

The repair kit for your Venture landing gear is the Lead Jack Repair Kit for Stromberg Carlson Landing Gear #LG-146059. It includes the gears and pins required for repairing the lead jack, or the leg that has the motor or crank on it. If you need the…

view full answer...

Availability of Lippert Venture Lead Leg Repair kit part # LC146059

Product Page this Question was Asked From

Continue Researching