Installation Kit Needed For Installing The Ventline Ventadome Trailer Roof Vent

Question

Question:

I am trying to order a V2092 SP-25 vent, which is easy.l However, how do I add the 344270 inaatallation kit??

asked by: Wayne K

1

Helpful Expert Reply:

To install your Ventline Ventadome Trailer Roof Vent # V2092SP-25 you'll definitely want the Roof Vent Installation Kit - Sealant, Butyl Tape, Screws # 344270KITW to go along with it. Having installed a vent before my one tip is to not be afraid to load up the sides with the self-leveling sealant. If you start at the base/on top of the RV and keep laying over top around the vent it will all settle down for a great water tight seal.

expert reply by: Kevin C

1

Answer 1

Based on your picture I do not believe you measured wrong and that you do have a 13"x13" roof vent, which is uncommon but with the age of your trailer not unheard of. You could install the Ventline Ventadome Trailer Roof Vent -…

view full answer...

Answer 2

The Ventline Ventadome Trailer Roof Vent #V2092SP-25 that you're referring to doesn't actually have a fan, it is just a roof vent. You could technically add a fan to your roof vent, with a fan blade #BVD0215-00, and a motor…

view full answer...

Answer 3

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a…

view full answer...

Answer 6

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 7

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in…

view full answer...

Answer 8

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 9

The Go Power Overlander Expansion Kit - 200 Watt Solar Panel item #34282182 has everything you need to connect to your existing Go Power Kit with the exception of extension cables. I have listed the lengths available below: 10' Go Power MC4…

view full answer...

Answer 10

The two most likely causes of a MaxxAir vent fan lid not opening or closing are either going to be a lift motor or operator failure. I recommend removing the motor and applying power directly to this to see if the shaft turns. If not, you know the…

view full answer...

Answer 11

Hi Eric; the Curt Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger #C52044 will work for your triple axle Kaufmann trailer. This is designed for 1 to 3 axle trailers with electric brakes so triple axle isn't a problem. As long…

view full answer...