Could Correct Track Alignment Lift Kit part # RR23QX Fit 2019 Mesa Ridge 2950BH

Question

Question:

Will this work on my 19 mesa ridge 2950bh?

asked by: Nate

0

Expert Reply:

Yes, the Correct Track Alignment Lift Kit part # RR23QX would work on your 2019 Mesa Ridge 2950BH.

expert reply by: Jameson C

0

Answer 1

You will not be able to use a lift kit since your axles are already under the springs. Your only option is to go with taller hangers. You will have to measure the height of your existing hangers and use the weblink I will be including below to find…

view full answer...

Answer 2

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Answer 3

Yes, our Dexter leaf spring part #DX74XR is the same as the part number 072-079-00. This is a 7-leaf spring for an 8,000 lb trailer axle that is 24-7/8 inches.

view full answer...

Answer 4

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 5

To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging freely, then measure directly across from the center of one spring eye to the other, as shown in the provided diagram. The height of the…

view full answer...

Answer 6

Yes, going from a 4 leaf to a 6 leaf spring would add slightly to your ride height. For example, if the current 4 leaf spring has 3/8" thick leaves, and you go to a 6 leaf spring with 3/8" thick leaves, you would be adding 3/4" of…

view full answer...

Answer 7

Thanks for the pictures! Since your 2022 Grand Design Reflection 303RLS came with the CRE3000 equalizers you will need three of the MORryde X-Factor Crossmember item #MR33WR. It looks like you have the standard 3" wide frame hanger so all of the…

view full answer...

Answer 8

The Universal Group 6-Leaf Double-Eye Spring #e64SR referenced in your question is designed for 7,000 pound axles like what you have on your trailer. Most likely this will work great as a replacement, however I cannot be sure that it is a direct…

view full answer...

Answer 9

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Personally Russ, if you are planning to keep your 2018 Grand Design Momentum 351M toy hauler and want to benefit from a better ride then upgrading to the Roadmaster Comfort Ride Leaf Spring Suspension Kit #RM-2460-2570 makes the most sense. If you…

view full answer...

Answer 12

The hangers you currently have on your trailer are ones I have run into before. That being said, I spoke with MORryde and the #MR27ZR will still fit your trailer, but there is a modification that will need to be made. You’ll have to trim according to…

view full answer...