Deadbolt Latch for Enclosed Trailer

Question

Question:

Do you sell a side door lock/dead bolt as addition to my factory bar lock it is an interstate cargo trailer thank you

asked by: Frank K

1

Helpful Expert Reply:

We have the Deadbolt Latch with Inside Safety Release for Enclosed Trailers # PLR7011S which is designed for rear and side doors on an enclosed trailer. The lock can be installed on either the left or the right-side of the door. The safety release allows the lock to be disengaged from the inside. We do not have one that is listed specifically for an Interstate Cargo Trailer.

expert reply by: Scott S

1

Answer 1

The Deadbolt Lock with Inside Safety Release part #PLR7011S does not have a handle attachment point. In most cases a handle is attached to the actual door and is used to open and close it while this is to keep it secure.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

To create barn doors out of your ramp door, you will need hinges and a latch. I suggest a latch/lock system like the Universal Cam-Door Lock for Enclosed Trailers - 1" Keeper, #383200. This will use a 3/4 inch diameter pipe that you'll have…

view full answer...

Answer 4

The Galeo Pro GPS Tracking Device #GA94FR has a motion sensor built in so it will "ping" the location whenever it moves or senses vibration. You can also press the "Locate" button within the app to get a ping on the tracker at any…

view full answer...

Answer 5

For your Parallax 555 model there isn't a converter replacement available. You'd have to replace the entire panel with the part #PD4560K18LS8. It does not come with breakers but in manual all of the required ones are listed from different…

view full answer...

Answer 6

While we don't carry the 10 cubic foot Furrion RV fridge I think I have a great solution for you to keep the doors shut when travelling with the Everchill 12-Volt RV Fridge Door Latch #324-000149. Once installed this will easily hold the doors…

view full answer...

Answer 7

A standard trailer dolly like #RA20 is not directly compatible with the Lock N Roll hitch system. There is not a dolly designed to work with that system, however if you were to use a similar system with the ability to attach to a hitch ball, then a…

view full answer...

Answer 8

For a travel trailer weighing 4,500 pounds, I recommend going with the Trailer Valet XL Trailer Dolly #TVXL2. The Trailer Valet XL is going to offer much better support for the tongue weight of your trailer than a standard trailer dolly. The Trailer…

view full answer...

Answer 9

We don't sell a 2-5/16 inch hitch ball with a 3/4 inch shank, but since a tow dolly is only used for small trailer movements across a parking lot your current hitch ball should work just fine. When using a tow dolly the tongue weight alone of the…

view full answer...

Answer 10

Yes, you do have the exact right replacement converter for your 45 amp Magnetek 6345, which is the option from Progressive Dynamics: - Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V I have added links below to…

view full answer...

Deadbolt Latch for Enclosed Trailer

Product Page this Question was Asked From

Continue Researching