What Size Is The Replacement Rhino Rack Security Allen Key?

Question

Question:

Is this 5mm

asked by: John K

0

Expert Reply:

Yes, the Replacement Rhino Rack Security Allen Key # SECKEY-S you mention is 5mm, and is the correct replacement for the Rhino-Rack Roof Rack for Factory Tracks # Y02-480-NT.

expert reply by: Bryce D

0

Answer 1

You would need to use the Allen key to remove the Rhino-Rack roof rack #RR78MR every time. But it isn't as difficult or time-consuming as it sounds. After you have done the initial installation and have taken the rack off and put it back on a…

view full answer...

Answer 2

Sounds like you are looking for either the standard length replacement Rhino Rack security key part #SECKEY-S or the long version part #SECKEY-L.

view full answer...

Answer 3

The first thing you would have to do is remove the bars. This can be done by using a 5mm Allen wrench and unscrewing the bolt underneath each foot. Then you would remove the legs from the base. I would use some lube on the locking levers just in case…

view full answer...

Answer 4

For your Rhino-Rack Ski and Fishing Rod Carrier, #RR572, you are looking for either the Replacement Rhino Rack Security Allen Key - Short, #SECKEY-S. Or, the long version part #SECKEY-L if you prefer a longer reach. Either works just fine for your…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…

view full answer...

Answer 12

The Rhino-Rack Heavy-Duty Roof Rack Roof Rack have specific C-channels that are designed to fit specific Rhino-Rack Heavy-Duty accessories, like the Rhino-Rack Hi-Lift Jack and Shovel-Holder Brackets #RRRCB-RSHB-RJHB as an example. That's the…

view full answer...