Replacement Security Hex Key Recommendation for Rhino Rack Roof Rack

Question

Question:

Hello, I may have lost the security hex key that is used to mount Rhino roof racks. Do you have replacement tools available? Thanks,

asked by: Rob G

0

Expert Reply:

Sounds like you are looking for either the standard length replacement Rhino Rack security key part # SECKEY-S or the long version part # SECKEY-L.

expert reply by: Jameson C

0

Answer 1

The first thing you would have to do is remove the bars. This can be done by using a 5mm Allen wrench and unscrewing the bolt underneath each foot. Then you would remove the legs from the base. I would use some lube on the locking levers just in case…

view full answer...

Answer 2

You would need to use the Allen key to remove the Rhino-Rack roof rack #RR78MR every time. But it isn't as difficult or time-consuming as it sounds. After you have done the initial installation and have taken the rack off and put it back on a…

view full answer...

Answer 3

Yes, the Replacement Rhino Rack Security Allen Key #SECKEY-S you mention is 5mm, and is the correct replacement for the Rhino-Rack Roof Rack for Factory Tracks #Y02-480-NT.

view full answer...

Answer 4

The roof rack you are describing is a fixed mount roof rack. The Rhino-Rack fixed mount racks have security bolts. As a result, you need a special torx wrench to remove them. You need the Replacement Torque Key for Rhino-Rack Accessories - Short -…

view full answer...

Answer 5

If the raised rails on your camper have a track, you will need the Rhino-Rack Quick Mount Legs for Vortex Aero Crossbars - RTC and RT Roof Rack Tracks - Qty 4, part #RRRLT600. These Rhino-Rack Legs will mount to the tracks in your rails on the roof…

view full answer...

Answer 6

According to Rhino Rack, the Replacement Rhino Rack Security Allen Key #SECKEY-S will work with all Rhino Rack products so this'll be the correct key.

view full answer...

Answer 7

Did you install the rubber strip in the upper and lower channel of the crossbars? What you described sounds like you are missing that as these are aero bars and should not be whistling at all. If there are any holes in the channel on the bottom or…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 11

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 12

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Replacement Security Hex Key Recommendation for Rhino Rack Roof Rack

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching