Hitch Recommendation for 2006 GMC Savana Van with a Knapheide Body
Question:
I have a 2006 gmc savana with a knapheide body and a step bumper. The hole placement is different than the video . The frame rails are 41.75inch wide to the outside. Wiill the c15320 fit?
asked by: Paul
Expert Reply:
The Curt # C15320 that you referenced should fit your 2006 GMC Savana with a Knapheide Body if your mounting holes have a 40 inch center. Although the outside measurement is relevant, the more important measurement is the mounting hole center to mounting hole center which is a standard 40 inches.
Providing you do have a 40 inch center, the Draw-Tite # 75189 will also fit.
Your step bumper is going to be the deciding factor when trying to pick out a hitch for your truck. If your step bumper is the standard factory bumper like the picture and you have a mounting hole measurement of 40 inches, then, either the Curt # C15320, Draw-Tite # 75189, or Reese # 45007 should fit.
You said that your frame rails were 41.75 inches to the outside - I pulled the Reese hitch and it has the same outside measurement that you are requesting - 41.75 inches and it has a 40 inch center. The Curt # C15320 and Draw-Tite # 75189 both have an outside measurement of 42-1/2 inches and center mounting holes of 40 inches.
In the picture, I have all three hitches installed on vans with factory step bumpers. If you happen to have a step bumper that is lower than the picture, the hitch will, more than likely, not fit on your vehicle.
With the variety of service vehicles that Knapheide assembles, I do not have a reference point as to which vehicle you have so I cannot verify your step bumper.
You will want to check out all 3 product pages because they have some differences, for example, the Curt and the Reese are Class V whereas the Draw-Tite is a Class III. With that simple difference it changes your tow ratings. Of course, you will have to check your owners manual to see what the tow rating is for your vehicle and choose from there. The other main difference is the Curt and the Draw-Tite have 2 inch receivers whereas the Reese is a 2-1/2 inch unit.
Products Referenced in This Question
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 7500 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class V XD - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class V
- 2400 lbs TW
- 16000 lbs GTW
- 17000 lbs WD GTW
- 2 Inch Hitch
- 2400 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class IV - 2"
- Video: etrailer Trailer Hitch Installation - 2020 Chevrolet Express Van
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: Trailer Wiring
- Shop: Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class V XD - 2"
- Search Results: c57672
- Search Results: hitch adapter
- Article: Trailer Wiring Diagrams
- Shop: Brake Controller
- Shop: Cordless Circuit Tester
- Shop: 7-Pole and 4-Pole Trailer Connector Sockets w/ Mounting Bracket and Wiring - Vehicle End
- Search Results: trailer hitch wiring
- Search Results: circuit tester
- Search Results: heat shrink butt connector
- Search Results: universal trailer wiring harness
- Search Results: hm40975
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Choosing the Right Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: My Trailer Hitch Doesn't Fit
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What Hitch Do You Recommend for a 2024 Toyota RAV4?
- Shop: Gooseneck Hitch
- Video: etrailer Class III Trailer Hitch Installation - 2024 Subaru Crosstrek
on Trailer Hitch
