What Is The Difference Between LC266149 And LC373566 Replacement Motors

Question

Question:

will this work ad a replacement for my solera awning?

asked by: Eileen

0

Expert Reply:

The Solera Power Awning Replacement Motor # LC266149 will work if your Solera awning was manufactured through 2015.

If your awning was manufactured after 2015, you'll want to use the Replacement Motor for Lippert Solera Power Awnings Manufactured after 2015 # LC373566.

expert reply by: Bryce D

0

Answer 1

The Solera awnings do not use a spring that applies tension on it so that won't be a concern. What you will want to do when installing the Solera Power Awning Replacement Motor #LC266149 is to bring the awning out about 12 inches or so and then…

view full answer...

Answer 2

Yes the gear pack part #LC78VR does work with both the motor kits you mentioned of #LC266149 and #LC373566.

view full answer...

Answer 3

With Solera awnings you will need to have the awning roller wound a total of fourteen times for proper spring tension. It could be yours was over-wound or maybe the motor is getting weak or your battery isn't in the best shape.

view full answer...

Answer 4

I reached out to my contact at Lippert and the Solera Power Awning Replacement Motor #LC266149 has not been tested with Dometic awnings for gearing compatibility, so they cannot confirm a fit. What you can do is replace the power drive head assembly…

view full answer...

Answer 5

If your Solera awning came with your 2015 Keystone Cougar then the part #LC266149 that you referenced should be the correct fit. However, if you have a Solera awning that was manufactured after 2015 then you need the replacement motor #LC373566…

view full answer...

Answer 6

Yes, the Solera Power Awning Replacement Motor #LC266149 will still work, it will just operate at a slower pace than your 100 RPM motor.

view full answer...

Answer 7

I checked with the manufacturer for you, and they say that the Solera Awnings are slower when they retract. If you are sure there are 12 volts by testing with a multimeter the next thing to do is ensure the pitch arms aren't bent at all, which…

view full answer...

Answer 8

The #LC266149 is designed to work with Solera awnings that were manufactured before 2014, where the #LC373566 is designed for awnings built after 2015. Yes, the main noticeable difference is going to be the plug, but that directly effects how it is…

view full answer...

Answer 9

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 10

The Replacement Amber Lens for MC32AB Trailer Lights #A32AB is a direct replacement for the SAE A P2 DOT 14 and would be what you'd need.

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...