What Lift Kit do You Recommend for My Triple Axle Dexter Axle 8459629?

Question

Question:

Hi I was looking for a lift kit for my fifth wheel trailer triple axle the axles already on the bottom so a flip kit will not be necessary I just needed something with some blocks and new U-bolts it is a dexter axle 8459629 Not sure if you guys carried anything that was a complete kit for that ?

asked by: Steven H

0

Expert Reply:

For using a lift kit on your triple axle, if you have double-eye leaf springs, I recommend three of the Correct Track Trailer Alignment and Lift Kit - Triple Axle # RR55QX. This particular kit will raise your axles by 1-1/4" or 2-1/4".

However, if you have slipper springs, you need to install trailer hangers. In order to know what particular setup you need, feel free to respond to this answer with a photo of your current suspension setup on your axles.

expert reply by: Bob C

0

Answer 1

To lift your triple axle Cyclone trailer, I recommend the Correct Track Trailer Alignment and Lift Kit item #RR55QX. This system attaches directly to your spring hangers and moves the mounting point down 1-1/4"-2" which lifts your trailer…

view full answer...

Answer 2

The two most common issues with resistors like part #DI34ZR are incorrect installation and the quick splice connectors not having enough contact with the circuit. I have attached for you below the correct wiring diagram for a load resistor but make…

view full answer...

Answer 3

The tallest tire we have in the size of ST235/85-16 is the part #LHWL410 which is 31.7 inches tall. We also have lift kits for trailer suspension like the part #RR23QX for a tandem axle trailer or part #RR55QX for a triple axle which can give a lift…

view full answer...

Answer 4

It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…

view full answer...

Answer 5

The trailer will have a plate or sticker on it that will list the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that will list the weight capacity. You can…

view full answer...

Answer 6

The MORryde Premium Rubber Suspension Kit #MR72TR is a great solution for triple axle trailers using the Correct Track Trailer Alignment and Lift Kit #RR55QX, and if your trailer has a 35" wheelbase. Wheelbase is measured from the center of one…

view full answer...

Answer 7

Basically the biggest difference between a Lippert 1116 and a Lippert 1716 is that the 1716 extends out further than the 1116. The 1716 is considered a long pin box whereas the 1116 is considered a medium length. The length difference will be 5-3/4…

view full answer...

Answer 8

To add two side cameras to your Furrion Vision S Wireless RV Backup Camera System with 5" Screen #FOS05TASF, you can use the Marker Light RV Side Cameras #FCE48TASL. I can understand your concern with the trailer having all LED lights, but it…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 12

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...