Winch Mounting Tray For A 2022 Jeep Gladiator Rubicon And A 12 Ton Badlands Apex Winch

Question

Question:

Will this work on the 2022 gladiator rubicon diesel ? Also, will it fit the 12 ton Badlands Apex winch ? Thank you !

asked by: Michael J

0

Expert Reply:

The Bulldog Winch Mounting Plate # BDW20208 you reference will not fit your 2022 Jeep Gladiator Rubicon. The Bulldog Winch Mounting Plate # BDW20208 is only compatible with select Jeep JK and JK Unlimited models from 2013-2016.

Instead, you'll want to use the Bulldog Winch Universal Winch Mounting Plate for Truck # BDW20008 which will work for your Gladiator, and will support winches 8k to 12.5k with a standard 10 x 4.5" bolt pattern.

Currently, we do not have any winch trays that will fit your 12 ton Badlands Apex winch, unfortunately.

expert reply by: Bryce D

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

The EcoHitch Hidden Trailer Hitch Receiver #EH35VR may interfere with the Hands-free Liftgate sensor like all of the other hitches. Typically this means you will need to place your foot on either side of the receiver tube in order to activate the…

view full answer...

Answer 6

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 7

We had a customer who was able to replace his Dexter 8-155 hubs with the #8-201-5UC3-EZ that you referenced so they should work well for you. You can verify that this hub will work for you by pulling your current hub and making sure they have inner…

view full answer...