What Does Red Light on NOCO Genius part # 329-GENIUS1 Indicate

Question

Question:

What does the red light m an and how do I get rid of it and turn it to green?

asked by: Thomas R

0

Expert Reply:

The pulsing red light on the Noco Genius part # 329-GENIUS1 indicates that the battery is less than 75 percent charged. To get rid of it you need to continue letting it charge. I attached a picture that has this explained as well.

expert reply by: Jameson C

0

Light Display Explained
(click to enlarge)

Answer 1

It sounds like you have a Genius2 just like the #329-GENIUS2. Just like the Genius1, there is a red pulsing light when the battery is below a certain percent. In this case it is either under 50% or under 25% based on where the light is located. See…

view full answer...

Answer 2

You will want to make sure your hood is open at least somewhat when using the NOCO Genius Smart Battery Charger - 1 Amp #329-GENIUS1. This will be the safest way to use the charger; the hood doesn't have to be totally open but if you can at…

view full answer...

Answer 3

Yes the NOCO Genius Smart Battery Charger #329-GENIUS1 that you referenced can be kept on a battery in long term storage like you mentioned. Once the battery is fully charged it switches to a maintenance mode that keeps it topped off without over…

view full answer...

Answer 4

Two 12 foot long bunks boards will work well to support your 21 foot boat. Ideally, the bunk boards should be at least half as long as your boat and run from the stern (or a few inches beyond it) to the bow as far forward as you like. Due to shipping…

view full answer...

Answer 5

It doesn't really matter which side of the crossmember of the trailer frame the bunk brackets install on. As long as they are torqued down properly either way will be perfectly safe. Since the brackets have swivels like #CE10003G-4 there would be…

view full answer...

Answer 6

Drilling a hole in your hitch receiver will void your manufacturer's warranty if something were ever to go wrong with it. For that reason, I think the best solution to use an anti-rattle hitch pin that won't require any drilling, like the…

view full answer...

Answer 7

You can put a maintenance charge on your trailer battery with the 12 volt accessory circuit of the 7-way. The 1:00 position of your 7-way carries this circuit. You would just need to run a length of 10 gauge wire like part #10-1-1 (sold by the foot),…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

What Does Red Light on NOCO Genius part # 329-GENIUS1 Indicate

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching