Weight Comparison of the Reese 5th Wheel Trailer Hitch with Round Tube Slider and Square Tube Slider

Question

Question:

What do both of these weigh?

asked by: Ernest S

0

Expert Reply:

The Reese 5th Wheel Trailer Hitch w/ Round Tube Slider, # RP30075 weighs 148 lbs.

The Reese 5th Wheel Trailer Hitch w/ Square Tube Slider, # RP30051 weighs 146 lbs.

Please note the linked product review videos below.

expert reply by: Michael R

0

Answer 1

In order to use the Reese 5th Wheel Trailer Hitch part #RP30051 you have on a 2018 Ford F-350 with the factory puck system, you are going to need an adapter. The correct adapter for you is the Reese Elite Series Underbed Rail Adapter part #RP30156. I…

view full answer...

Answer 2

The Curt E16 5th Wheel Trailer Hitch part #C16515-16020, and the B&W Companion OEM 5th Wheel Trailer Hitch part #BWRVK3370 are great options for your 2019 Ford F-250. That said, the B&W Companion is in a league of its own. The B&W…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the "new…

view full answer...

Answer 6

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 11

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 12

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Weight Comparison of the Reese 5th Wheel Trailer Hitch with Round Tube Slider and Square Tube Slider

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching