Options for Bathroom Vent for 2017 Jayco Hummingbird

Question

Question:

I would like to install a bathroom vent in my 2017 Jayco Hummingbird. What options are available?

asked by: Rick C

0

Expert Reply:

You could use the MaxxAir Mini Deluxe Trailer Roof Vent w/ 12V Fan # MA00-03851 as a bathroom fan. It's an exhaust fan that would do an excellent job in this application.

If you'd rather use the larger in size MaxxFan Deluxe Roof Vent w/ 12V Fan # MA00-05301K you certainly could as well. The fan moves quite a bit more air and is reversible too which you might find helpful.

expert reply by: Jameson C

0

Answer 1

All of the friction sway control units like the Curt #17200 that you referenced require drilling into the trailer frame. We do have electric sway control units like the Tuson part #335TSC-1000 which uses sensors to detect trailer sway and apply the…

view full answer...

Answer 2

To install the Curt Friction Style Sway Control System, part #17200, to your trailer will require drilling holes in the trailer frame. Drilling the few holes that are needed in the side of the tongue for installation of the sway control will not…

view full answer...

Answer 3

We don't offer a product like the EAZ Lift sway control adapter you mentioned, but if you don't care for the idea of attaching the ball to the trailer frame using screws, you could certainly have the ball/plate included with the #83660 kit…

view full answer...

Answer 4

I reached out the manufacturer, Airxcel, and was informed that all of their fans, including the #MA00-05301K, have motors with brushes and ball bearings in them.

view full answer...

Answer 5

The MaxxFan Deluxe Roof Vent w/ 12V Fan - Manual Lift - 4 Speed - White part #MA00-05301K does have a rubber weather seal around the lid and helps to prevent leaks. It is not considered air tight but it will prevent rain and condensation from leaking…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 12

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...