Recommended Front Mount Hitch For A 2006 Dodge Ram 3500 4x4
Question:
I’m looking for a front hitch to put a winch on. I’d like to see if you have one that fits where the tow hooks go. Thank you..
asked by: Kyle M
Expert Reply:
The front mount hitches we have available for your 2006 Dodge Ram 3500 (Curt # C31017 and Draw-Tite # 65046) will both mount under the bumper, which I have examples of in an included picture. With that said, we do not have an option that will mount up at the tow hooks, unfortunately.
Both of these hitches are rated to 9,000 pounds of line pull, but the Draw-Tite # 65046 is rated to 500 of tongue/vertical load, which will be higher than the Curt's 350 pound capacity. Between the two, I recommend the Draw-Tite due to this.
As a side note, if you do not have a mounting plate for the winch yet, I can also recommend the Curt Electric Winch Mount Plate # C31010. With the addition of the Winch Mount Handles # C31005, it will not only give you a good place to mount the winch, but will also be a lot easier to get installed in the hitch.
Products Referenced in This Question
Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- Draw-Tite
more information >
Curt Trailer Hitch Winch Mount Handles
- Accessories and Parts
- Electric Winch
- Handles
- Mount Handles
- CURT
more information >
Curt Trailer Hitch Electric Winch Mount Plate
- Accessories and Parts
- Electric Winch
- Mounting Hardware
- Plates
- Without Handle
- CURT
more information >
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 350 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Front Mount Hitch
- Shop: Front/Center/Rear Hanger for Double-Eye Springs - 2-3/8" Tall - 9/16" Bolt Hole
- Shop: Single-Axle Trailer Hanger Kit for Double-Eye Springs - 1-1/2" Front, 1-1/4" Rear
- Shop: Shackle Bolt with Locknut for Double-Eye Springs - 3" Long
- Shop: Nylon Bushing - 9/16" Inner Diameter, 11/16" Outer Diameter - 1-3/4" Long
- Shop: Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: Trailer Hitch
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Search Results: front mount motorcycle carrier
- Search Results: front receiver hitch
- Video: Best 2006 Dodge Ram Pickup Hitch Options
- Video: Dexter Axle Trailer Brakes - Electric Drum Brakes - K23-086-087-00 Review
- Shop: Trailer Wiring
- Search Results: 44649
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Choosing the Right Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Video: EcoHitch Hidden Front Mount Trailer Hitch Installation - 2021 Ford F-250 Super Duty
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Search Results: 68149
- Article: Trailer Wiring Diagrams
- Shop: Brake Controller
- Search Results: 25580
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Video: Choosing the Right Brake Controller
- Video: etrailer Magnetic Hitch Receiver Reducer Sleeve Review
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Shop: Fifth Wheel Hitch