Replacement Hitch Receiver Hardware for a 1984 El Camino

Question

Question:

I have the hitch that was on my 1984 el camino at one time. I was wondering if you offered the installation hardware required for install, sold separately?

asked by: Jon M

0

Expert Reply:

For the 1984 El Camino we offer the Curt Trailer Hitch Receiver item # C12005. You can purchase the hardware kit separately for it. It is the Replacement Hardware Kit for Trailer Hitches item # RHK. You will need to go to the page and put C12005 where it says Hitch Item Number and then you will put Curt where it says Manufacturer.

expert reply by: Jerred H

0

Answer 1

The outside width of combo bar #80948 is slightly less than 2-1/2 inches so it would fit in a 2-1/2 inch receiver. But this bar is meant for hitch fabrication and not meant as a hitch extender. For a 34 inch extender that is rated for use as an…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 5

The first thing you'll need to flat tow your 2015 Chevy Malibu LS is a base plate kit like the Roadmaster part #RM-523178-5 that is a confirmed fit. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting,…

view full answer...

Answer 6

Yep, so long as your 2024 Subaru Crosstrek Wilderness is not a hybrid both the Curt and etrailer hitches will fit: - Curt Trailer Hitch Receiver #C13382 - etrailer Trailer Hitch Receiver #e98912 The only difference besides price is the finish; the…

view full answer...

Answer 7

Hello Craig. I do have a solution for you, but the Flint Hill Goods Wheelchair Carrier #FHG99ZR is not recommended for use behind RVs, campers, or trailers. The ride on the back of a 5th wheel or RV is a lot more rough than on the back of a car or…

view full answer...

Answer 8

To keep your back end from squatting, I recommend the Coil SumoSprings Custom Helper Springs for Coil Spring Suspension item #CSS-1094R. These insert into your rear springs and keep your suspension from being pushed down by the weight of your…

view full answer...

Answer 9

That is a keen observation and a good question. I actually had the chance to assist with assembly of one of the Flint Hill Goods 30" x 50" Wheelchair Carriers #FHG99ZR not too long ago. The main bolt for the shank is indeed quite large, so…

view full answer...

Answer 10

What you need is the Roadmaster Brake Lite Relay Kit part #RM-88400. This will prevent your brake pedal brake light activation from overriding the turn signals like you are experiencing.

view full answer...

Replacement Hitch Receiver Hardware for a 1984 El Camino

Products Referenced in This Question

Featured Help Information

Instructions

Continue Researching