Replacement Gear Box for Ram Jack # TJD2SP-12000SP-F

Question

Question:

LOOKING FOR A REPLACEMENT GEAR BOX FOR TJD2SP-12000SP-F. ALL IN CAN FIND IS FOR THE 12900, AND THE SHAFT IS DIFFERENT.

asked by: AUBREY

0

Expert Reply:

We have a replacement gear box for the # TJD2SP-12000SP-F with the part # TJD2SP-12900-GBX. The part # 12900 is the same as the 12000.

expert reply by: Jameson C

0

Answer 1

It will not; there are no replacement detent balls available unfortunately so you'll need to replace your 12000 Series jack with the Square 2-Speed Jack #TJD2SP-12000SP-F.

view full answer...

Answer 2

Yes, there is another option to add a brake controller to your Sierra. Since you have the factory tow package, I recommend the Curt Echo In-Line Wireless Brake Controller item #C79DR. The controller plugs in behind your 7-way with included…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

For your Dometic DuoTherm the Advent Air Unit part #ACDOM150 would be your best option that will give you the higher BTU rating 15k and easily connects to the current wiring you have now.

view full answer...

Answer 11

The first thing you will need for your 1999 D250 is a 4-way. The Curt T-Connector Vehicle Wiring Harness #C55317 plugs into the connection points behind your rear bumper and will allow you to power your trailer's signal lights. Once the 4-way is…

view full answer...

Answer 12

Sure thing, I will go ahead and list out what you need for your 2023 Kia Sportage to add a 7-way for a brake controller so you can tow with the Curt Trailer Hitch Receiver #C94WR: - T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector…

view full answer...