What is the Spacer Plate That Comes In The Curt Friction Sway Used For?

Question

Question:

why use the spacer plate

asked by: Wilbur B

0

Expert Reply:

The spacer plate that is included with the Curt Friction Sway Control # 17200 is for alignment purposes. It is not required for all installations but has been included by Curt in the event that it is required. The plate will also provide additional support to the frame giving it a larger surface area to prevent the ball mount from damaging thinner frames or aluminum frames.

expert reply by: Bud M

0

Answer 1

Self tapping screws like the ones used in the Curt Friction Sway Control for Weight Distribution Systems #17200 aren't meant to be torqued down. Simply drilling them into the frame until they pull the bracket tight against the frame is all…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The 23-5/8 inch width is the widest point and is actually for the metal rod. The bracket width is 22-1/8 inches from edge to edge. I measured this product for you to confirm and have attached a photo to assist.

view full answer...

Answer 6

There is a weight distribution hitch option for your new 2021 Intech Flyer Discover with a completely covered A-frame. Instead of using a standard weight distribution hitch which has brackets that go around the frame you will need to use a weight…

view full answer...

Answer 7

According to my research, if your 2019 Mercedes-Benz Sprinter 3500 came with a factory 7-way trailer connector you will have the brake controller connector pre-wired. This pre-wired connector should be under the driver side seat which you can see in…

view full answer...

Answer 8

Both the kits come with the same Curt Spectrum Trailer Brake Controller #C51170 for your 2018 Volkswagen Atlas. The Universal Wiring Adapter #C51515 is needed if your Atlas does not have the factory brake controller wiring. While the Curt Custom…

view full answer...

Answer 9

We don't know for sure if the #CFSRE21SA002 will fit on your Amana RV stove since they're not designed for the same product, but I can tell you that the grates are 19" long (wide) and will sit 1-3/8" tall. The front grate is…

view full answer...

Answer 10

Yes, you can use the Reese Friction Sway control part #83660 without a weight distribution system. You would just need to use the tab part #RP26003 on the ball mount as well.

view full answer...