Can Sway Control be Used on a Trailer without Using Weight Distribution

Question

Question:

Can i just use a sway control without weight distribution system? thanks

asked by: Bob

0

Expert Reply:

Yes, you can use the Reese Friction Sway control part # 83660 without a weight distribution system.

You would just need to use the tab part # RP26003 on the ball mount as well.

expert reply by: Jameson C

0

Answer 1

According to B&amp;W, the #BWTS20067BMP cannot be used with a weight distribution setup. Even if it could, the hole spacing wouldn&#39;t match for you to attach your weight distribution system. You will have to stick with a weight…

view full answer...

Answer 2

The shank portion of the B&amp;W Tow &amp; Stow Pintle Hook/Hitch Ball #BWTS10056 cannot be used as a component of a weight distribution system. B&amp;W designed this adjustable pintle/ball combo hitch to offer the flexibility…

view full answer...

Answer 3

Valley went out of business a few years ago, so their products are no longer available. I&#39;d recommend the B&amp;W Class V hitch, part #BWHDRH25230. The hitch is a three piece design, with the side plates and center section being…

view full answer...

Answer 4

The Curt Friction Sway Control, #17200, can be used without a weight distribution system like you mentioned by using the Reese Sway-Control Bracket you referenced, #RP26003. This system helps to fight trailer sway, but only after it begins by…

view full answer...

Answer 5

The B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2" #BWHDRH25182 is shown with the factory 245/70-17 tire which has a 30-1/2 inch diameter. The 285/70-17 tire you mentioned is 32.7 inches diameter so it…

view full answer...

Answer 6

Some items in a trailer or RV will run off of 12 volt DC power or AC power so if your fridge runs when not connected to shore power then it will run off of the battery. That battery can receive a maintenance charge from the 12 volt circuit on a…

view full answer...

Answer 7

To remove the 3" cap on your Valterra Sewer Drain like #T30A I recommend using the FloTool GRIPTECH 3-Position Adjustable Pliers #FT10627GT which can be adjusted between 2-3/4" and 4" to give you extra leverage in removing…

view full answer...

Answer 8

I spoke to Yakima about the StraightShot #Y69VR extender, but they have only tested this with Yakima accessories. Due to this, it doesn't have a listed tongue weight. With that being said, the Yakima bike racks and other accessories are going…

view full answer...

Answer 9

While I can sympathize with your issue, it is not safe to tow a trailer if you only have a 2" hitch ball and your trailer coupler is designed for a 2-5/16" hitch ball, even for a short distance; the insecure connection between hitch…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is…

view full answer...

Answer 11

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only…

view full answer...

Answer 12

Is your bolt pattern a 6 on 5-1/2 inch or a 5 on 6-1/2 inch like you mentioned? I believe you are looking for 6 on 5-1/2 inch as that is the standard size. For 15 inch tire sizes that would at least match your axle capacity you'd need to go…

view full answer...

Can Sway Control be Used on a Trailer without Using Weight Distribution

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching