Troubleshooting A Blue Ox Patriot That Pulsates Constantly
Question:
I installed the Patriot 3 in my 2021 Jeep gladiator and the trial run went fine but when I went to install it for a trip when I powered it up and hit the on switch it immediately started pulsating none stop and I hadnt hit the setup button yet. I tried hitting the setup button hoping it would stop and setup but it just keeps pulsating, I tried adjusting it to make sure there wasnt to much pressure on the brake pedal but it still does the same, so Im not sure if I need to go back to the manufacturer or if you might have some suggestions? Please Advise.
asked by: Joe K
Expert Reply:
I would first remove the power to your Blue Ox Patriot Portable Braking System - Proportional # BLU37TR for a few minutes to let it reset. Check the 12v outlet using a tester like # PTW2992 to ensure the unit is actually receiving 12v power as insufficient power could also be causing issues.
Next check to see if there is a short in the wire for your breakaway switch. You could have a small cut, bend, or loose connection causing the sporadic pulsating. Once you know the outlet is properly powering the unit and you have no issues with the breakaway switch you can go ahead and stick the unit back in place and plug it in following the installation/setup steps listed in the attached manual.
If you are still experiencing these issues then I recommend reaching out to Blue Ox directly as there may be some internal defect.
Products Referenced in This Question
Product Page this Question was Asked From
Blue Ox Patriot Portable Flat Tow Brake System - Proportional
- Tow Bar Braking Systems
- Brake Systems
- Proportional System
- Recurring Set-Up
- Portable System
- Power Assist Brake Compatible
- Air Brakes
- Air Over Hydraulic Brakes
- Hydraulic Brakes
- Blue Ox
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Base Plate for Tow Bar
- Shop: Trailer Wiring
- Article: What Jeeps Can Be Flat Towed?
- Video: etrailer SD Non-Binding Tow Bar Installation - 2021 Jeep Wrangler
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2021 Jeep Cherokee
- Shop: Replacement Breakaway Kit for Brake Buddy Classic and Select Flat Tow Brake Systems
- Shop: Roadmaster Falcon All-Terrain Tow Bar - Non-Binding - RV Mount - 2" Hitch - 6,000 lbs
- Shop: Replacement Breakaway Kit for Brake Buddy Digital Classic Flat Tow Brake System
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: etrailer Invisible Base Plate Kit - Removable Arms
- Shop: Roadmaster Accessory Kit for Nighthawk and Sterling Tow Bars - Tail Light Wiring - Lock Set
- Shop: etrailer SD Non-Binding Tow Bar for Roadmaster Direct-Connect Base Plates - RV Mount - 6,000 lbs
- Q&A: Troubleshooting Flashing Yellow Lights of Lippert Ground Control
- Q&A: Is a Mopar Flat Tow Wiring Harness Needed for a 2021 Jeep Grand Cherokee
- Q&A: Is Mopar Flat Tow Wiring Harness Required For 2019 Jeep Cherokee Trailhawk
- Search Results: brk2520
- Video: Review of Blue Ox Tow Bar Braking Systems - USB Remote Power Cable - BLU99XR
- Q&A: Powering and Troubleshooting Blue Ox Patriot
- Q&A: Replacement Power Cord for Blue Ox Patriot 3 Braking System Monitor
- Q&A: Does Blue Ox Patriot Portable Braking System Require Connection To Vehicle Battery
- Q&A: Troubleshooting Loss of Communication Between Blue Ox Patriot Unit and Controller
- Shop: Vehicle Tow Bar Brake System
- Search Results: patriot
- Search Results: base plates
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Hitch
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Vehicle Tow Bar Wiring
- Video: Blue Ox Patriot Portable Braking System Installation - 2022 Ford F-150
on Tow Bar Braking Systems
