Bolts Wont Thread On etrailer Hitch for 2013 Toyota RAV4
Question:
I have read all of the information regarding the flex issues with the hitch and obviously that is a problem with the hitch I purchased, will try to make it work. But I also have an issue with two of the bolts sent not threading, they seem to large. I have cleaned the bolt holes and again, two fit but 2 do not. I received an email to leave a review but before doing so, I wanted to reach out and get some assistance.
asked by: Jackie M
Expert Reply:
The etrailer Trailer Hitch Receiver part # e98864 which is a fit for a 2013 Toyota RAV4 comes with M12-1.25x35mm hex bolts. These will match up with the weld nuts in the frame. If the vehicle is older, the chances of the weld nuts being dirty is high. They can usually be cleaned out with a wire brush and lube but sometimes they require tapping with a thread tap. The vehicle uses four of the same size bolts so I don't think you got the wrong size.
Unfortunately, hitches get bent during shipping and it's not impossible for them to be welded incorrectly either. These can usually be fixed by some slight bending it but we can get an exchange as well if it's too severe.
Product Page this Question was Asked From
etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 525 lbs WD TW
- Visible Cross Tube
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Q&A: etrailer Hitche for 2007 Toyota RAV4
- Search Results: bike rack
- Search Results: bungee cords
- Video: etrailer.com Trailer Hitch Installation - 2018 Toyota RAV4
- Shop: RV Bike Racks
- Shop: Erickson Bungee Cords w/ Plastic Safety Hooks - Qty 12
- Shop: Hollywood Racks RV Rider Bike Rack for 2 Electric Bikes - 2" Hitches - Frame Mount
- Shop: Erickson Flat Bungee Cord w/ S-Hooks - 18" Long - Qty 1
- Shop: Trailer Wiring
- Article: My Trailer Hitch Doesn't Fit
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: Which Hitch Requires the Least Modification On 2015 Toyota RAV4
- Shop: Transmission Cooler
- Video: Best 2011 Toyota RAV4 Trailer Wiring Options
- Video: Best 2011 Toyota Rav4 Trailer Hitch Options
- Q&A: Why Doesn't the Bolt on My Etrailer Hitch # e98859 Fit the Bolt Brackets?
- Q&A: Troubleshooting Trailer Hitch Receiver Bolts That Won"t Install in Factory Weldnuts
- Q&A: What is Towing Capacity for 2016 Honda CR-V
- Video: Choosing the Right Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Search Results: hitch
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector