Recommended Replacement Vent For A 2007 Forest River Rockwood Ultra Light Travel Trailer

Question

Question:

I have a 2007 Rockwoid Ultra light camper. 8296 SS is the model. I want to replace the vents on the roof. Do you know what size? Do you sell the vents? I prefer tinted. Or can I change the cracked top and the screen instead of replacing the whole thing?

asked by: Susan H

0

Expert Reply:

RV manufacturers do not list the vents they use, however we can replace the covers without knowing the brand. You can use the Replacement Lid for Jensen, Ventline, Elixir, and Ventadome RV Roof Vents # A10-3376 which has its own replacement hinge that will screw into your current vent without having to know what hinge yours currently has.

You can also use the Fan-Tastic Vent Ultra Breeze Trailer Roof Vent Cover # DMC38FR which will mount to the roof of your RV and allow you to leave your vent open rain or shine and also while driving.

Most RV vents are 14" x 14" so if you want to completely replace your vents I recommend the MaxxFan Deluxe Roof Vent w/ 12V Fan # MA00-07500K which also can be ran while it's raining or snowing. The reversible, 10-speed fan has a thermostat to regulate airflow inside your RV. Ceiling fan mode circulates air when vent is closed. The remote control with LCD screen allows you to set the thermostat and the fan speed and direction.

expert reply by: Kevin C

0

Answer 1

For your MaxxFan Plus Roof Vent w/ 12V Fan, Thermostat, and Remote #MA00-04500K, the MaxxAir FanMate Rain Cover is your best fit for fully functionality. These come in 3 colors: Smoke #MA00-955003 White #MA00-955001 Black #MA00-955002 This will allow…

view full answer...

Answer 2

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 3

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this point…

view full answer...

Answer 4

For the front legs of a Lippert Ground Control 3.0 kit the replacement front jack leg solution you'd need is the part #LC362485. This will allow you to reuse your current motor and bracket. There isn't a gear replacement kit for the jack…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

To determine the correct cover, you will need to measure the vent opening. The most common openings are 14 1/4" x 14 1/4", and have vents that are 14" x 14". After you make your measurements, you will need to determine what type…

view full answer...

Recommended Replacement Vent For A 2007 Forest River Rockwood Ultra Light Travel Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching