Roof Vent Cover for Ventline RV Roof Vent

Question

Question:

Hello! Which roof vent cover will work for our bath fan Ventline VD0434?

asked by: Jen K

0

Expert Reply:

The MaxxAir vent cover part # MA00-933069 will fit your Ventline roof vent. It fits standard roof vents like what you have as it was designed to basically be universal.

expert reply by: Jameson C

0

Answer 1

Most roof vents follow the standard size opening. That size is 14-1/4 inches by 14x1/4 inches but it is most commonly referred to as 14 x14. Many different vents on the inside and outside flanges can have different measurements to gain a certain look…

view full answer...

Answer 2

I went and pulled a Kenda Karrier ST205/75R15 Radial Trailer Tire with 15" Black Mod Wheel #AM32424 from our warehouse to determine the weight capacities and found that on the sidewall it was stamped Load Range D with a 2,150 lb capacity at 65…

view full answer...

Answer 3

You would need the standard MaxxAir Vent Cover part #MA00-933069 as a vent cover for the top of your Ventline E-Z Lift Ventadome #V3094-603-00C.

view full answer...

Answer 4

You would need the standard MaxxAir Vent Cover part #MA00-933069 as a vent cover for the top of the Ventline E-Z Lift Ventadome #V3092-603-00. This cove allows you to leave the vent open even if there's rain and not worry about water getting in.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Roof Vent Cover for Ventline RV Roof Vent

Product Page this Question was Asked From

Continue Researching