RV Safe Propane Gas And Carbon Monoxide Detector Dimensions

Question

Question:

Replacing an old Atwood LP detector. Hole size is 31/4” x 4”. Will the 2-Wire RV Propane Gas and Carbon Monoxide Detector cover the hole?

asked by: Del

1

Helpful Expert Reply:

The 2-Wire RV Propane Gas and Carbon Monoxide Detector # RS54FR is a flush mount design that has a cover plate with 7-1/4" length x 3-3/8" height x 1/4" thick with mounting holes that are center to center 6" apart so you should be able to easily cover the hole from your previous LP detector.

expert reply by: Kevin C

1

Answer 1

The 2-Wire RV Propane Gas and Carbon Monoxide Detector #RS54FR comes with 2 different mounting brackets. I have included the measurements to both brackets and a video that includes these measurements beginning at the 1:10 mark of the video. The long…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

We do have some LP gas detectors available, but none would be a direct replacement for your CCI 7770.2 / Pre Tell 22. From what I could find on your CCI 7770.2 / Pre Tell 22, it has dimensions of 6.25" wide x 3.9" tall. The RV Propane Gas…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 9

Atwood is no longer in business so you'd have to switch over to a new brand in order to get what you need. We currently only carry the RV Propane Gas #RS44FR (white #RS64FR) which comes with two different trims (large: 7-1/4" long x…

view full answer...

Answer 10

Based on what you are saying, it sounds like the detector is faulty and needs to be replaced; you did the right thing with vacuuming it and checking the batteries, as those are the two steps that need to be taken to ensure there isn't a…

view full answer...

Answer 11

I definitely understand being a bit overwhelmed by the amount of options in front of you, however I can definitely help with differentiating the trailer hitches for your 2019 Subaru Outback Wagon along with explaining my personal recommendation,…

view full answer...

Answer 12

Hey Cliff, with the Replacement Controlled Motion Hinge #LC95VR to get the desired effect where the door doesn't swing open or closed all you have to do is replace is a single hinge and not all three.

view full answer...

RV Safe Propane Gas And Carbon Monoxide Detector Dimensions

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching