RV Safe RV Propane Gas and Carbon Monoxide Detector Review Video

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

I recommend the #RS34FR to replace your current LP gas detector. This is a simple 2 wire design making for easy installation.

The closest option we'll have to your Atwood 33535E LP/CO2 Detector is going to be the RV Propane Gas and Carbon Monoxide Detector #RS54FR that you were already looking at. It comes with two mounting plates to try and eat up some of your…

Yes, the Atwood carbon monoxide detector part #AT36681 replace the 33535E that you have now.

The most likely cause for the turn signals not to work when the running lights are on with your trailer is a bad or weak ground. It's very possible that a weak ground connection can be just strong enough to allow sufficient current for some…

Yes, the 2-Wire RV Propane Gas and Carbon Monoxide Detector, #RS54FR has two different mounting brackets to select from allowing coverage of the existing hole from previous installs. Please note the attached product review video.

The RV Propane Gas Detector part #RS64FR for white or part #RS44FR for black is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you…

The Atwood 31013 is no longer made. The best choice for replacement is the RVCO #RS34FR which mounts flush against the wall, and the overall measurements are 4-1/4" square, and it sticks out 1/2" from the wall. Works with 2-wire…

We do have some LP gas detectors available, but none would be a direct replacement for your CCI 7770.2 / Pre Tell 22. From what I could find on your CCI 7770.2 / Pre Tell 22, it has dimensions of 6.25" wide x 3.9" tall. The RV Propane Gas…

The problem you are having is a classic ground issue. If the ground wire to the trailer frame or the tail light grounds are not connected securely to clean, rust and paint free surfaces then when the headlights are turned the extra amperage draw for…

Since you found low voltage when testing the right side signal light pin on the vehicle connector, you have at least isolated the issue to the truck. If all the wires appear to be in good condition, then the issue is likely either a weak ground like…

For a replacement combination LP Gas/CO detector for your RV you can use Atwood part #AT36681. It is intended for installation at no more than 18" from the floor and both include a mounting plate.