Weight Capacities of Hitch Box Extension and Reducer RP45292 at 24 inch

Question

Question:

what is the maximum tongue weight on a 2,5 x2,5 sq. 2 ft long extension and towing capacity

asked by: Jeffrey J

0

Expert Reply:

In the 24 inch configuration of the Reese hitch extender part # RP45292 that you referenced the capacities are:

600 lb tongue weight and 6,000 lb trailer weight.

expert reply by: Jameson C

0

Answer 1

The Thule Apex #TH9027XT has similar dimensions to the Yakima Full Swing #Y02465 and will come in contact with your spare tire if you try to swing the back trunk door open. I attached a picture where we tried this bike rack with a Jeep with a spare…

view full answer...

Answer 2

Using the hitch extension will reduce the tongue weight capacity of the trailer by 50 percent. But if you have a 2 1/2 inch trailer hitch receiver and use the Titan hitch extension #RP45292 the tongue weight capacity will not be reduced. At the 24…

view full answer...

Answer 3

The best solution we would be the Titan Hitch Box Extension #RP45292 which can be cut down to 24 inches in length. When used in the 24 inch length it has a 6,000 lb trailer weight capacity or 8,000 lbs if you use it with a weight distribution…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 10

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 11

Hello Steve. I do have a good solution for you, but I cannot recommend using the Malone Adapter #MPG544. Since it is rated for towing only 4,000 lbs, your 8,000 lb towed vehicle would be double the max towing capacity. You are right about there being…

view full answer...

Answer 12

As long as the flat tow wiring is wired in before the 4-Way #C93ZV and you connect the power for the converter directly to the battery it will work. I have seen several use Magnetic Lights #TL21RK which they will wire in on the main harness to have…

view full answer...

Weight Capacities of Hitch Box Extension and Reducer RP45292 at 24 inch

Product Page this Question was Asked From

Continue Researching