Will the TorkLift Trailer Hitch and Rear Camper Tie Down Fit a 2007 GMC Sierra 2500 Diesel Exhaust

Question

Question:

My truck has a large cone at the aft end of the exhaust pipe. There is not much clearance between the cone and the bumper. The Torklift R3502 tiedowns are specified for this hitch. Will these tiedowns clear the available gap?

asked by: Wesley R

0

Expert Reply:

If you have a factory diesel or gas exhaust then the TorkLift SuperHitch Original Trailer Hitch Receiver part # TLC1206 will fit a 2007 GMC Sierra 2500 New Body 6-1/2' Bed. Once installed, you can then install the TorkLift Custom Frame-Mounted Camper Tie-Downs part # TLR3500 which again will fit models with the factory exhaust.

If there are any aftermarket exhaust modifications, neither the hitch or tie-down would be confirmed.

expert reply by: Conner L

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 6

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 7

The proper extension for your setup would be the one that allows you to have clearance of your hitch mounted accessory and also allows you to still be able to pull the steps down. If the receiver tube sticks out past the camper too far then you will…

view full answer...

Answer 8

The current Torklift tie down part #TLD3101 that you have installed on your 1997 Dodge Ram 3500 only fits if you have the factory hitch. If you go with the SuperHitch part #TLD1100 you would need to change your rear tie down to the part #TLR3503.

view full answer...

Answer 9

We do offer hitch extensions for the factory 3" trailer hitch receiver on your 2017 Ford F-350 Super Duty, but there is not one that is 24" long. The shortest extension available is the TorkLift Cannon Hitch Extension - 3" Ford Super…

view full answer...

Answer 10

The 1-5/16" Hellwig Adjustable Big Wig Rear Anti-Sway Bars are designed for 2WD #HE97MR or 4WD #HE94FR versions of your 2021 Ford F-250. These are both designed for trucks which have a stock ride height. Hellwig does offer their 2" Lift…

view full answer...

Will the TorkLift Trailer Hitch and Rear Camper Tie Down Fit a 2007 GMC Sierra 2500 Diesel Exhaust

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching