Recommended Spring Seats To Install New 5200lb With Leaf springs ABOVE The Axle

Question

Question:

Do you have 5200lbs axles for under leaf spring setup?

asked by: PAUL

0

Expert Reply:

I have an option for you, but we do not offer a 5200lb axle with the spring seats oriented so that the leaf springs are above the axle.

Instead you will need to remove the spring seats and have a qualified welder weld new ones on the other side of the axle.

For the Dexter Trailer Axle w/ Electric Brakes # 8327816-EB you were looking at you will need two of the spring seat # TRSS300.

I included videos of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

We have exactly what you're looking for with bearing kit #BK3-300. This includes one inner bearing and race, one outer bearing and race, the correct grease seal and a cotter pin for your Dexter 5,200 lb axle. For cross reference I'll…

view full answer...

Answer 2

Trailer axles are supposed to have a bow in them that faces down towards the ground. With the weight of the trailer normally this flattens out slightly and gives you the correct camber you need. Whoever flipped your axle should have used an over…

view full answer...

Answer 3

The minimum distance between side wall of the tire and and trailer frame depends on the trailer, you definitely don't want the tire and the trailer to touch so 2" of clearance is a safe distance however you may be able to get away with less…

view full answer...

Answer 4

The minimum distance between the inside of a tire and the frame rail depends a lot on the setup of the trailer. But as long as the tire and the frame don't touch you would be fine. It's hard to give an exact figure as trailer setups can vary…

view full answer...

Answer 5

If you keep the trailer tires inflated to the maximum psi indicated on the tire sidewall then they should not bow out on the sides enough to cause any clearance problems between the tire and the trailer. A 1/2 inch space could be enough but it is…

view full answer...

Answer 6

The recommended amount of tire clearance to allow for suspension travel on virtually any trailer is 3" from the top of the tire to the bottom of the fender or frame and 1" from the inside of the tire to the frame. If you need to raise the…

view full answer...

Answer 7

Great question. As a general rule, when your trailer is loaded to it's full capacity, there should be a minimum clearance of 3 inches between the top of your tire and the underside of your fender.This should give you adequate clearance for…

view full answer...

Answer 8

I have another option for you, but we do not have any 13" trailer wheels with offset to push the tire further from the frame, and do not recommend using any spacers as they can cause additional stress on the hubs which can wear out bearings and…

view full answer...

Answer 9

The minimum distance between the inside of a tire and the frame rail depends a lot on the setup of the trailer. But as long as the tire and the frame don't touch you would be fine. It's hard to give an exact figure as trailer setups can vary…

view full answer...

Answer 10

To have enough clearance for the trailer to travel over bumps in the road you want to have at least 3 to 4 inches between the tire tread and the fenders as well as 1 to 2 inches between the side wall and inside of the wheel well. The smallest tire…

view full answer...

Answer 11

I'm assuming you're speaking of the clearance between the top of the tire and the fender/wheel well. Four inches of clearance between the tire/fender and two inches clearance to the inside is what we typically want to see, but 3 inches to the…

view full answer...

Answer 12

The general recommended "sweet spot" for clearance between the side of your tire to the frame is 1-2 inches from the inside edge of the tire to the frame.

view full answer...