Can the Superwinch Winch 2 Go Portable Winch

Question

Question:

Can I use a jump pack to power the winch 2 go?

asked by: Tedd S

0

Expert Reply:

This is a great question!

According to my contact at Superwinch, a jump box would give you enough power for single full-length pull with the # SW1140222. A fully charged 230-Ah motorcycle battery would do about the same.

expert reply by: Erik B

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Great news! I can help you find the brake controller harness on your truck. Since you have a factory tow package on your 2016 Toyota Tacoma you will have a plug for a brake controller in your dash. According to the instructions on the #3031-P harness…

view full answer...

Answer 3

The Rhino Rack ROC25 part #RR46XR has a 165 lb dynamic weight capacity which means that's how much it can carry while travelling and incurring the standard bumps and movement that creates. While Rhino Rack doesn't give a static weight…

view full answer...

Answer 4

The Superwinch Winch 2 Go Portable Winch #SW1140232 would need to be bolted down to your enclosed snowmobile trailer in order to attach. I added a photo of the winch which shows the underside of the winch and the mounting holes. They are spaced apart…

view full answer...

Answer 5

The LT3000 winch, #SW1130220, is a good choice for pulling a 2,350 pound vehicle onto your trailer. With a rolling load (your vehicle) on a 17 degree slope (typical range for a trailer ramp) the winch will have a 7,825 pound rolling load capacity.…

view full answer...

Answer 6

The Superwinch Winch 2 Go 4000 SR, part #SW1140232, is designed fto operate with power input from the batteries typically found in lawn tractors, ATVs, UTVs or motorcycles. Naturally, the higher the battery capacity the more running time. According…

view full answer...

Answer 7

Curt hitch ball #40038 has a 1 inch diameter shank. For Curt balls with 3/4 or 1 inch diameter shanks you would use wrench #C20001. The nut on that ball should use the 1-1/2 inch end of the wrench. You could also use a large crescent wrench if you…

view full answer...

Answer 8

We aren't manufacturers of those parts, and we don't have the testing ability in house, so I reached out to a couple of our manufacturers to see what information they could provide to try and help. I reached out to my contact at Curt…

view full answer...

Answer 9

I would be happy to help. The correct replacement return spring for the jack feet on your 10,000lb side wind jack will be dependent on which brand it is. For example if you have an etrailer or Ram branded jack such as the #TJD-12000SP-F2 then you…

view full answer...

Answer 10

The Superwinch S7500 Trailer Winch #SW1475201 is designed to have more of a "universal" style for mounting and may require some adaption for installation because it does not have a typical mounting pattern. The Superwinch S7500 Trailer…

view full answer...