Draw-Tite Front Mount Trailer Hitch Installation - 2015 Toyota Tacoma Video

I've got good news; we've previously confirmed with Truxedo that the TruXedo Lo Pro Soft Roll-up Tonneau Cover - Black #TX556901 will fit with your factory cargo rails on your 2006 Toyota Tacoma with a 6 foot bed. This is a nice, roll…

I contacted Curt on your behalf and they confirmed for the Curt Front Mount Trailer Hitch Receiver #31313, the side carriage bolts should be replaced with the installation kit bolts and there shouldn't be plastic fittings to remove there. For…

Normally the skid plate can reinstall after the front hitch part #31313 is installed but on the TRD models the skid plate is different and can't be.

When installing Curt front mount receiver #C31075 it is just the air dam that will need to be trimmed on the 2016 Toyota Tacoma. I have included a picture that shows where the trimming needs to occur. I have also linked the instructions for you.

For the TRD models there is fascia trimming required when installing the Curt front hitch part #C31075 that you mentioned. I attached a picture that shows where the trimming will be.

The fish-wire that is referred to in the instructions is highlighted in the attached picture; this is going to be the way to get the bolts set up in holes that are tough to access otherwise. We do not have an install video for this specific front…

I took a look at the install instructions for the Ranch Hand Legend Grille Guard on your 2018 Toyota Tacoma and compared that to how the Curt Front Mount Trailer Hitch Receiver part #C31075 installs. Unfortunately, the two products will use the same…

I recommend using the Draw-Tite Front Mount Trailer Hitch Receiver #65070 for your 2019 Toyota Tacoma because it has the highest weight ratings which indicates a stronger hitch. This has a 2" receiver and is a custom fit so it doesn't…

Draw-Tite front-mount hitch #65070 is a confirmed fit on your 2012 Toyota Tacoma 4WD. We have not had a chance to install this particular item nor the Curt equivalent #31313 on your same truck so for purposes of seeing the effect on your ground…

The best front mount hitch available for your 2019 Toyota Tacoma TRD is the Curt #C31075. This particular hitch will still require you to trim the skid shield to allow for the needed clearance but unlike the Draw-Tite alternative it will allow you to…

You actually will not loose any ground clearance with Curt front mount receiver #C31075 installed on your 2017 Toyota Tacoma. The receiver will not be lower than the lowest part of the front fascia on the truck. I have included a picture showing the…

The etrailer hitch part #e98905 that you referenced fits all models of the 2018 Toyota Tacoma including the 4 cylinder models so it would work great for you.