Finding Replacement Keys For Kuat Bike Rack

Question

Question:

i have a 2018 or so kuat hitch rack for bikes and need new keys. The front of the lock core is 108. do you have something that will fit this?

asked by: Scott

0

Expert Reply:

In the past, you would be able to match up a key with the lock code as the one you provided and you would then get replacement keys for your Kuat NV 2.0 Bike Rack # NV22B. Now, Kuat offers Replacement Lock Cores for Kuat Cargo Carriers and Bike Racks # LOCO4 as a replacement. This includes 4 lock cores, 2 keys, and a change key. I attached a helpful demonstration video for you to check out.

expert reply by: Andrew N

0

Answer 1

In the past, Kuat would be able to match keys with lock cores based on the code, but now that is not necessary as you would just need to order Replacement Lock Cores #LOCO for your Kuat NV Bike Rack #NV22B. This comes with 2 lock cores, 2 keys, and…

view full answer...

Answer 2

The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…

view full answer...

Answer 3

When wiring a trailer connector, it is best to wire by function, as wire colors can vary. We have an excellent wiring diagram on our website, I will provide you a link so you can look at it. If you are looking at the inside of the trailer connector…

view full answer...

Answer 4

The integrated locks for your Kuat NV 2.0 Bike Rack like #NV22B will have the key number stamped both on the keys themselves and on the lock cores right above the key slot. The numbers on the keys are pretty small and hard to read but there should…

view full answer...

Answer 5

The Everchill Refrigerator for RVs #324-000119 only operates on electric. 12v volts to be specific.

view full answer...

Answer 6

As long as you have the room to fit the 23-1/2" wide x 24-3/4" deep x 59-5/8" tall Everchill Refrigerator #324-000119 you can definitely use it as a replacement for your Dometic refrigerator. Attached is a photo showing the…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are…

view full answer...