Replacement Key CH503 For Tractor Supply Truck Tool Box

Question

Question:

Does this key work for my tractor supply tool box also

asked by: Dariel

0

Expert Reply:

If your Tractor Supply tool box lock cylinder is stamped with the CH503 than the Replacement Key # KEYCH503 is the correct replacement key. The keys and lock cylinders can be used across a large variety of products.

expert reply by: Bud M

0

Answer 1

For the pair of ramps that come with the #325-GH-R72 the total weight is 61 lbs.

view full answer...

Answer 2

We have the replacement key part #KEYCH506 which is for UWS toolboxes that has a similar key number to what you have. We have seen these keys fit other brand toolboxes before so there is a strong chance it will work for you as well.

view full answer...

Answer 3

The CH506 is a very common key for UWS and other brand toolboxes, but without knowing the brand of toolbox you have, I couldn't guarantee it would work. However, the #KEYCH506 key is pretty inexpensive so If I were a gambling man I'd bet that…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 7

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...

Answer 8

I attached a picture that shows the proper position of shackles and equalizers on trailer suspension. Sometimes the shackle will flip up but if you jack up the trailer by the axle that's got the shackle flipped you can usually get it to flip back…

view full answer...

Answer 9

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 12

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Replacement Key CH503 For Tractor Supply Truck Tool Box

Product Page this Question was Asked From

Continue Researching