Availability Of Replacement Kwikee Step Motor To Replace Older Step Motor 5973820

Question

Question:

i have a 1999 holiday rambler motorhome and the step motor is bad. I am having trouble finding the correct replacement. its a kwikee 32 series double step and the numbers off the old one is 5973820.

asked by: Nathan J

0

Expert Reply:

We have exactly what you are looking for!

The correct replacement step motor for the Kwikee 32 Series double step with step motor number 5973820 on your 1999 Holiday Rambler motorhome is the Replacement Motor with Mounting Plate for Kwikee Electric RV Steps # LC379608. This will be an direct replacement for your motor.

I included a video of the # LC379608 for you to take a look at.

expert reply by: Samuel C

0

Answer 1

We have the exact replacement you need for motor 1101422 on your 2015 Forest River Berkshire motorhome, which is the following: - Replacement Motor for Kwikee Electric RV Steps #LC379147 If you need to replace the gear box as well, that part is the…

view full answer...

Answer 2

The linkage arm only comes with the gearbox so you would need to purchase the whole assembly #LC379160 to replace the broken linkage arm on your Kwikee 38 Series RV steps on your 1999 Monaco Diplomat Class A Motorhome.

view full answer...

Answer 3

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 6

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 7

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 8

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...

Answer 9

I have attached for you below some common torque values needed for a trailer suspension system but a lot of these will vary by bolt size and other factors. U-Bolts: Varies by Size - 1/2" bolts: 45 ft/lbs - 70 ft/lbs, 9/16" bolts: 65 ft/lbs…

view full answer...