Installing A Furrion Camera On A 2020 Grand Design Momentum 399th For Security Observation

Question

Question:

Have side makers and backup just need cameras but would like security camera with motion sensor does this record activity

asked by: Richard L

1

Helpful Expert Reply:

The Furrion Vision S Wireless RV Backup Camera System w/ 3 Cameras - 5" Screen # FCE48TASL-05 can be wired into your running lights to be used for observation/security but the monitor does not have recording features so you would only be getting a live feed. Each camera has motion detection to trigger your monitor to power on. The Quad screen displays up to 4 camera angles simultaneously or allow you to select a single camera to enlarge a specific viewpoint.

expert reply by: Kevin C

1

Answer 1

For your 2017 Ram 3500 you would not need a rail system depending on which hitch you get; the one you referenced, the B&W Companion #BWRVK3600 for example, will fit directly in the puck system of your truck. This would be a fantastic choice,…

view full answer...

Answer 2

The B&W Companion OEM 5th Wheel Hitch #BWRVK3600 has a total weight of right around 215 pounds. Keep in mind that the hitch head can be removed to help with taking the hitch out of the truck bed. The head by itself weighs about 75 pounds while…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

Because your trailer has a Turning Point pin box and your Ram has a 6.5' bed I do recommend going with a fixed hitch and using the Turning Point as a rotating pin box to give yourself enough turning clearance. With you also having a puck system…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…

view full answer...

Installing A Furrion Camera On A 2020 Grand Design Momentum 399th For Security Observation

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching