JT's Strong Arm Compatibility With Snap Pads On Electric Travel Trailer Stabilizers

Question

Question:

Can the JT Strong arm system be used with electric stabilizers and RV Snap Pads?

asked by: Mary A

0

Expert Reply:

Yes, the JT's Strong Arm Jack Stabilizer Kit for Travel Trailers # LC191025 can be used on electric stabilizers. The Electric Stabilizer Jack Pad Adapter # LC314597 will allow you to attach the Strong Arms to the jack pad. These adapters can be either bolted on or welded on to stabilizers.

They will not interfere with the SnapPad XTRA Jack Pads # SN99FR or other pads that you have and are specific to your travel trailers stabilizers.

expert reply by: Bud M

0

Answer 1

On the front landing gear legs of an RV you install two of the JT's Strongarms of part #LC191025 like what you see in the attached picture and install video. This is why the kits come with 6 arms total. Four for the front and 2 for the…

view full answer...

Answer 2

The bar holding up your water tank wouldn't be a useable crossmember since it's just there to hold the tank up and isn't as structurally sound as an actual frame beam to handle to pressure the JT's Strong Arm Jack…

view full answer...

Answer 3

I went our to the warehouse to measure the eye to eye distance on the arms of the JT's Strong Arm Jack Stabilizer Travel Trailer Kit #LC191025. From the center of one eye to the center of the other it was exactly 26 inches.

view full answer...

Answer 4

I went out to the warehouse to measure the length of the arms when extended for the JT's Strong Arm Jack Stabilizer Kit #LC191025. From the center of the hole on one end to the center of the hole on the other end it measures 46 inches…

view full answer...

Answer 5

Yes the JTs Strongarm kits like #LC191025 could be used on a narrower frame width trailer frame like yours that has 56-3/4 inches between scissor jacks.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have…

view full answer...

Answer 8

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

JT's Strong Arm Compatibility With Snap Pads On Electric Travel Trailer Stabilizers

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching