Dimensions of the CE Smith Tie-Down Bracket for Boat Trailers # CE26214G

Question

Question:

Hi, What are the dimensions of this tie-down bracket? Also, the info states that the galvanizing creates a 3 to 5mm coating. This should be 3 to 5 mil, not mm! 3mm would be a bit over 1/8. Just worth noting. Thanks,

asked by: Dave

1

Helpful Expert Reply:

I went and pulled a CE Smith Tie-Down Bracket # CE26214G from our warehouse to measure the dimensions and found that the overall length is 4 inches, the width is 1-15/16 inches, the bigger hole is 7/8 of an inch and the smaller hole is 9/16 of an inch.

Check out the video I attached that shows me taking these measurements.

expert reply by: Jameson C

1

Answer 1

The Optronics LED Combination Trailer Tail Lights #TLL160RK will replace your tail lights for LED on your Heritage trailer. If you are able to remove the clearance lights from their bases we have the following Amber/Red lights below. Thinline LED…

view full answer...

Answer 2

The “SAE P2PC 98” you provided is a code used by the department of transformation and will not have any bearing on the correct replacement. In order to determine the correct replacement I would need you to either A) remove the lens and find the part…

view full answer...

Answer 3

The smaller hole of the CE Smith Tie-Down Bracket #CE26214G is the mounting hole that secures the bracket to the trailer. The smaller hole is 9/16 of an inch and the larger hole is 7/8 of an inch. The bracket has a 30 degree angle to it. I apologize…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 12

Hey Sean! As long as you don't have anything placing a draw on the Bright Way Solar Battery Charger #BRW54FR, and the 4-6 hours of sunlight is unrestricted then this kit will be just fine for keeping your Group 24 battery topped off.

view full answer...

Dimensions of the CE Smith Tie-Down Bracket for Boat Trailers # CE26214G

Product Page this Question was Asked From

Continue Researching