Flat Towing a 2007 Suzuki XL7

Question

Question:

Can a 2007 Suzuki XL7 be flat towed? What will i need to safely connect it to my RV?

asked by: Ronald B

0

Expert Reply:

You will need to refer to you vehicle specific owners manual as to whether your 2007 Suzuki XL7 can be flat towed; trim levels, transmission options and other vehicle specific options all need to be considered to determine if a vehicle can be flat towed safely and without damage occurring. If you determine that your 2007 Suzuki XL7 can be flat towed you will need the following items:

A base plate kit. I suggest the Demco Classic Base Plate Kit, # DM9518137. This is a confirmed fit for the 2007 Suzuki XL7.

I suggest the Demco Commander II Non-Binding Tow Bar - Victory Series, # DM9511012. This has the needed safety cables with it.

For brake lights I suggest the Heavy Duty Magnetic Tow Lights - 20' Wiring Harness with 4-Way Flat Trailer Connector
Item # TL21RK as these are the most cost effective way for needed indicator lights when flat towing.

It is now require by law to add a supplemental brake system for vehicles being flat towed, I recommend the Stay-IN-Play DUO, Item # SM99251.

Please note the attached product review and installation videos available, links below and on each product page.

expert reply by: Michael R

0

Answer 1

To replace your Shurflo 2088-422-174 fresh water pump, I recommend the Flow Max RV Fresh Water Pump #LC689052 instead of the HydroMax RV Fresh Water Pump #P25201 because the Flow Max will draw a maximum of 8 amps, as opposed to the 10 amps of the…

view full answer...

Answer 2

You CAN tow your Rogue behind a motorhome, but it cannot be flat towed with all 4 wheels down. FWD vehicles like your 2019 Nissan Rogue can't be safely flat towed because even with the vehicle place in Neutral, the transmission would still spin.…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Hey Dave, so the best option for carrying your carbon frame bike and e-bike is the Swagman Escapee part #S39SR with the ramp #S59SR . It has the capacity for carrying an e-bike, is rated for travel trailer use, only touches the bikes by the tires…

view full answer...

Answer 8

Yes, you can install a Curt Trailer Hitch Receiver #C11433 on your 2019 Chevrolet Spark. This receiver is capable of supporting up to 200lbs of tongue weight. With each of the Lectric 3.0 e-bikes weighing roughly 60lbs without the battery you will…

view full answer...

Answer 9

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 10

Yes, for 5,200 standard trailer axles we have the hub part #8-219-4UC3-EZ which is a fit for 5,200 lb axles and has the bolt pattern of 8 on 6-1/2 inches like you said you need.

view full answer...

Answer 11

At the rear of a trailer or RV the ride quality is very rough when compared to the ride quality at the rear of a passenger vehicle. Reason being the suspension isn't as sophisticated and there is a longer distance between the rear axle and the…

view full answer...

Answer 12

As long as the flat tow wiring is wired in before the 4-Way #C93ZV and you connect the power for the converter directly to the battery it will work. I have seen several use Magnetic Lights #TL21RK which they will wire in on the main harness to have…

view full answer...