Which LaSalle Bristol ThermaHeat Pad Replaces the SL-T1218G

Question

Question:

Mine dont work. I need to order more. One of the numbers on one pad is: is SL-T1218G-10G. I dont see than number on your site. Has there been a change in product?

asked by: Tom N

0

Expert Reply:

It's possible that the SL-T1218G-10G part number is an older number that just isn't showing up, but those numbers at least partially correspond to the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 18-1/4" Long x 12" Wide # 277-000164. This pad is 12" wide and 18" long.

If you need a different sized ThermaHeat pad let me know and I can see if that is available.

expert reply by: Erik B

0

Answer 1

There's nothing stopping you from using a Holding Tank Heater Pad such as #277-000164 on black or gray water tanks. However with the black water tank adding a heat source could create excess gases which could be a potential problem.

view full answer...

Answer 2

You may not have to squish the Therma Heat RV Holding Tank Heater Pad #277-000164 at all. It would need to be in contact with the plastic tank since it cannot be mounted on a conductive surface. What you can do though is once it is installed and you…

view full answer...

Answer 3

We've had this question before and the manufacturer of the ThermaHeat #277-000164 that you referenced has stated that it's okay to insulate over the heating pad.

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 8

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 11

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 12

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Which LaSalle Bristol ThermaHeat Pad Replaces the SL-T1218G

Product Page this Question was Asked From

Continue Researching