Which Adapter for Curt Sliding Hitch to Factory Pucks in 2021 GMC Sierra 2500

Question

Question:

Hi I have a Curt Q20 slider hitch that was installed in a Ford F-250 with the hitch bed rails. And I now have a 2021 GMC 2500 the new truck has the bed puck system. Which bed puck rail part # works to adapt the Q20 slider to this new truck. Don’t need to buy another complete bed hitch. Thanks

asked by: Jim M

0

Expert Reply:

You'll want to use the Adapter Rails for Curt 5th Wheel Hitch - Ford and Chevy/GMC Towing Prep Package # C88KR which will give you a rail kit style adapter to use your Curt Q20 slider hitch with the factory pucks on your 2021 GMC 2500.

expert reply by: Erik B

0

Answer 1

The Curt 16027 which we offer as part #C88KR adapter provides industry standard bed rails that are compatible with Reese, Curt, Demco, B&W, Valley and Husky 5th wheel hitches, among others.

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Hey Richard, thanks for reaching out! The Air Lift LoadLifter 7500 XL Air Helper Springs #AL57541 does take up the same space as the Curt 19419346 5th wheel bracket kit for your 2024 GMC Sierra 3500. The only way to remedy this is to use the…

view full answer...

Answer 6

The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package #BWRVK3775 you're looking at will work fine with your new Chevrolet Silverado. This hitch has 3 height adjustments so you'll be able to set the hitch height…

view full answer...

Answer 7

As far as height adjustability and weight capacities the Curt Q20 #C16130 and the Curt A20 #C16140 are identical. They both have a Gross Towing Weight of 20,000 lbs, a Vertical Load Limit of 5,000 lbs, and a height range of 13-17 inches. When it…

view full answer...

Answer 8

The head alone for the B&W Companion hitch #BWRVK3500 weighs about 70 pounds. Everything else weighs about 130 pounds. So the total weight of the hitch is approximately 200 pounds.

view full answer...

Answer 9

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 10

That's weird, the 7-Way Vehicle Power Adapter for Furrion RV Observation Camera #FR87PR should allow you to use your camper at the same time as that's what it's designed for. If you want to just avoid the adapter all together, I would…

view full answer...

Answer 11

Yes there is! The Husky 31326 hitch is made to fit the industry standard fifth wheel rails (ISR). The Curt Adapter #C88KR is also made to the same industry standard measurements. So the Curt Adapter #C88KR will be exactly what you need to use your…

view full answer...

Answer 12

Most fifth wheel rails are made to the same industry standard dimensions. They aren't all though. If you measure 22 inches on center between the two rails and they look like the rails of the #RP30035 that you referenced they would be the industry…

view full answer...