Rear Anti-Sway Bar Compatibility For A 2021 Ford F-250 Super Duty

Question

Question:

Will the Roadmaster Rear Anti-Sway Bar Item # RM-1139-145 fit the 2021 Ford Tremor/Gas?

asked by: Robert S

0

Expert Reply:

The Roadmaster Rear Anti-Sway Bar tem # RM93VR is a confirmed fit for your 2021 Ford F-250 Super Duty but the Roadmaster Rear Anti-Sway Bar Item # RM-1139-145 you were looking at is not a confirmed fit.

expert reply by: Kevin C

0

Answer 1

Good question, and while we do have a rear anti-sway bar for your 2019 Ford F-350 Super Duty, the #RM-1139-173 is only for trucks that already have one, and there isn't a hardware kit that will allow installation of this anti-sway bar on a…

view full answer...

Answer 2

There is not any drop required, nor will there be any interference with the helpers on your 2020 Ford F-350's overload springs to install the Roadmaster Rear Anti-Sway Bar #RM93VR.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...