Should Brackets of Lippert 3.0 Front Landing Jacks Rest on Jack Tab
Question:
Hello, I have a factory installed ground control 3.0 leveling system. We have twice had the front jacks slip within the mounting bracket. Where should the mounting clamp sit vs the weld tab on the Jack? Other systems I have seen the weld tabs are located on the sides and the bracket sits under them, touching. On my set up they are not close. Thank you,
asked by: Jay T
Expert Reply:
The bracket should be resting against the tabs of the jacks so that there's no chance it can slip. I am not sure what they were thinking when they installed yours like that but you need the direct contact between the bracket and the tab.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Shop: Replacement Controlled Motion Hinge for RV Entry Door - 6 Leaf - White
- Shop: Fogatti RV Tankless Water Heater - Gas - Automatic Pilot - 41,800 Btu - Black
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Shop: Lippert Carpet Protectors for RVs with Slide Outs - Qty 2
- Shop: Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU - 16" x 16" Door
- Shop: Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System - 10,000 lbs
- Search Results: rv jacks
- Search Results: stabilizer jacks
- Search Results: rv stabilizer
- Article: Trailer Wiring Diagrams
- Search Results: 44649
- Q&A: Brake Controller Installation on 2016 Mercedes-Benz Sprinter
- Shop: Trailer Hitch
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: 68149
- Shop: Trailer Wiring
- Video: Review of Ultra-Fab Products Camper Jacks - Landing Gear - UF17-943010
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Shop: Fifth Wheel Hitch
- Q&A: How to Bleed Electric Over Hydraulic Trailer Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: dust cap
- Video: etrailer Stabilizer Jack Review
- Shop: Suspension Enhancement
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Hole To Hole Dimensions For Replacement I-Beam Jack Bracket # LC349975
- Search Results: 25580
- Q&A: Adding Brakes to a Mobile Home Axle
- Article: Determining Trailer Tongue Weight