Parts Needed to Flat Tow a 2006 Honda Accord Behind a Motor Home

Question

Question:

I am installing a tow bar on my car last time I had to install a diod to get the motoer home taillights to work on the towed car I know this is ment for a trialer lights but if power was put to the plug would it work in reverse for the tail and stop lights while being towed

asked by: Sam

0

Expert Reply:

Regular trailer wiring harnesses will not work in reverse. they are designed to fail if that is done to protect the vehicle wiring from damage if there were a short circuit on the trailer. You will need a kit specifically designed for flat towing. You can use a diode kit such as # 154-792-118158.

You will also want to consult your vehicle owners manual on the proper procedure for towing the vehicle.

If you need base plates on your 2006 Accord use # 1545-1 if it is not a Hybrid. For a compatible tow bar and safety cables use # RM-522 and # RM-645.

Most states now require supplemental braking on the vehicle being flat towed and the easiest system to set up and use is the Even Brake proportional system # RM-9400. It applies the vehicle brakes in proportion to how much the tow vehicle is braking. This is the safest way to stop and it reduces wear and tear on both vehicles.

If your Accord is a Hybrid and has continuous power-assist brakes then you cannot use the Even Brake but you can use the Patriot # BLU37TR. I have included some helpful links on flat towing for you to view.

expert reply by: Michael H

0

Sam

3/22/2013

Thanks for the reply and all the parts numbers I ordered the diode kits.

Reply

Answer 1

First let's start with a base plate for your 2000 Honda Accord. For that the most popular option is the Roadmaster XL Base Plate kit part #1545-1. In addition to the base plates, you will also need a compatible tow bar, safety cables,…

view full answer...

Answer 2

We do carry base plates for your 1999 Honda Accord. Take a look at the XL Base Plates, #1545-1. These are the correct base plates for your vehicle. I also recommend safety cables and a light kit as required by law. For safety cables, I recommend…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Yes, the Roadmaster Tracker Tow Bar part #RM-020 that you referenced can be used to flat tow a 2002 Honda CR-V that has the correct Roadmaster base plate kit installed on it. If your CR-V does not have the factory brush guard you would want the part…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 7

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

We do offer tow bar setups that can attach to the D-rings on the Warn Elite Bumper. Your will need to use a D-ring adapter to connect the tow bar. For the adapter you have the following options: 1" Thick D-Rings #RM-035-1 3/4" Thick D-Rings…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Gladly! The difference between the Blue Ox Patriot 3 Radio Frequency, Portable Braking System BRK2019 and the Blue Ox Patriot Radio Frequency, Portable Braking System #BLU37TR is that the Blue Ox Patriot 3 RBRK2019 is older, no longer available, and…

view full answer...

Answer 12

The instructions for the Demco Tabless Base Plate Kit #DM77YV are being added to page but I'll also send them to you separately. In the instructions they only show that the air dam needs a chunk cut out and that the shutters would remain. The…

view full answer...