Firman 3,300-Watt Portable RV Generator Specifications

Question

Question:

Can this be connected to a pressure-regulated quick connect on an RV or does it require unregulated supply from a tank? What is the noise level at full load?

asked by: Rob

0

Expert Reply:

The Firman 3,300-Watt Portable RV Dual Fuel Inverter Generator - Propane or Gas - Electric Start Item # FIR54FR can be hooked up to your camper/RV with a quick disconnect propane hose. You'll need to make sure the regulator on your camper is set to match the needs of this generator. The regulator specification for this generator is 11/14 water column, Maximum Working Pressure of 1 psig, Maximum of 150,000 BTUs/hr.

The noise level at full load is approximately 58 decibels.

expert reply by: Kevin C

0

Answer 1

It looks like there are a couple of different Honda 3000 generators. Based on the length, width, and height of those you could use the TorkLift Lock and Load carrier #TLA7752. The tray measures 27-3/4 inches by 24 inches. I have linked a video review…

view full answer...

Answer 2

I checked with Firman and they were able to provide me with the rough dimensions of the Firman 3,300-Watt Portable RV Dual Fuel Inverter Generator - Propane or Gas - Electric Start #FIR54FR. This generator is going to be 27" long x 18" wide…

view full answer...

Answer 3

The water column (WC) rating of the Single Stage Propane Regulator part #108072 would be far too high for your generator. Instead, you are going to want to use a two-stage regulator like the MB Sturgis Vertical 2-Stage Propane Regulator part #108220…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

With the size of your Champion Generator 200953(23.4" wide, 27.9" long and 21.7" tall I recommend using the 32x48 Reese Solo Cargo Carrier #PS1040100. This has a 47-3/4" long by 31-3/4" wide inner tray and can support up to…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

We do have the panels separately. What you're looking for is the Go Power Overlander Expansion Kit - 200 Watt Solar Panel #34282182.

view full answer...

Answer 8

We have the perfect solution but the Furrion Vision S W is not compatible with the pre wiring from Voyager. Instead the Voyager WiSight Wireless RV Backup Camera #ASA24YR is the way to go. This will allow you to use the already existing bracket to…

view full answer...

Answer 9

Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Since the Truxedo Lo Pro you'd have installed on your 2013 Chevy Silverado 3500HD long bed would be the part #TX571601 the correct replacement tarp would be the part #TX5716-CVR.

view full answer...

Answer 12

The Air Lift Wireless AIR Compressor System #AL74000 will show an error whenever there is any type of issue with the system. Generally this is an issue with the remote communicating with the system, a blockage, or a leak. I would inspect the…

view full answer...