Which L-Ping Clip For Fastway Replacement L-Pin FA92-03-9205?

Question

Question:

Can you tell me what the correct L-pin clip is for L-pin FA92-03-9205?

asked by: Steve R

0

Expert Reply:

I would be happy to help!

The correct L-Pin clip for the Replacement L-Pin for Fastway e2 Weight Distribution Systems # FA92-03-9205 you were looking at is the Replacement L-Pin Clip for Fastway e2 Weight Distribution Systems # FA92-04-9208.

I included a video of the # FA92-03-9205 for you to take a look at.

expert reply by: Samuel C

0

Answer 1

Thank you for all of the info. I went out to the warehouse and found that from the back side of the face of the lock to the arm it did indeed measure about 5/8" as you can see in the attached photo. The Camco Cam Lock #CAM44340 comes with both a…

view full answer...

Answer 2

The replacement L-pin part #FA92-03-9205 that you referenced fits Fastway e2 kits that are 6,000-lb, 8,000-lb, 10,000-lb, or 12,000-lb.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

To activate the brakes on a trailer with your 2024 Toyota Grand Highlander you'll need a 7-way connector and brake controller. To switch over from your 4-pin connector you can install the #ETBC7L. This will plug into your 4-pole connector and…

view full answer...

Answer 5

It sounds like you're looking for the spring bar retention bracket for your Reese Pro Round Bar Weight Distribution #RE94FR. The correct replacement is the Replacement Spring Bar Retention Bracket Kit #RP58498.

view full answer...

Answer 6

Good question, and what happens is that leaf springs elongate over time, and since you mentioned you got measurements of 25-1/2 inches from center eye to center eye and 26 inches under partial load, the best option for leaf springs really is the…

view full answer...

Answer 7

To swap out the 800 lb tongue weight spring bars of your E2 system to 1,000 lb spring bars you would want the part #FA92-01-1099.

view full answer...

Answer 8

The 'sleeve' or shank portion of the Fulton #F500266 caster assembly is meant to be compatible with Fulton F2 trailer jacks, which is why it's kind of oddly shaped. At the widest point, that sleeve is 2-1/2 inches in diameter, as shown in…

view full answer...

Answer 9

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

view full answer...

Answer 10

We definitely have some trailer jacks you can use as a replacement for your Dutton-Lainson but it doesn't look like anything we have will work as a direct replacement. If you'd like to stick with the Dutton-Lainson brand then I recommend…

view full answer...

Answer 11

The reason why you would need the #VGR74VR filter to use the #ASA37YR is because your 2022 GMC Sierra 1500 will have pulse width modulation (PWM). This means it won't send consistent power back to the camera and you're going to lose the…

view full answer...